Be sure to read these instructions for use and keep them in a safe place These operating instructions apply o the How to use the electronic models § 849 and 6491 timer (with electronic timer} Cleaning and care illustrations 415 What Before lulling fof the first time 18 | {something does not work) Using the hotplates 18-21 Service 22-28 28127 28 28
Before using for the first time Set ling the electronic timer As soon as the electrician has connected the control panel to the power supply the indicator it above the time symbol {Figure @74} and the electronic timer (Figure /1) will stats flashing. First of all set the time of day after which the hotplates will be ready for use. The time is set as follows: first of all set all switches to "0, Then set the time of day with the knob (Figure @ /3) (it must be pushed In and turned clockwise).
Cooking utensils and hotplates Hints for cooking on hotplates W Protect your hotplates from moisture otherwise the plates will start 20 rust. Always ¢ry the bases of your utensils \before placing on the hotplates. R Keep the hotplates clean at all times because dirty plates will nat produce full heating power. Ideally use utensils (s8) which are exactly the same size as or larger than the hotplates. The utensil acts fiche a shield o the hotplate (in case for example soup ete. bolls over).
Using the hotplates The word “hotplate” is used here 10 mean both cast iron hotplates and ceramic radiant areas. The control panel of your cooker has two automatic hotplates {Figure @/2) and two high speed hotplates (Figures The symbols under e contra nabs indicate which knob belongs to which hotplate. The hotplate Is OFF when the “0" is under the dot {Figure@ ).
Boiling and frying on the automatic hotplates Thai automatic control erasures that the hotplate switches over automatically from beating up (full power) to boiling (power Switching on with automatic control ® Place the food to be billed on the ring. I' Turn the switch to the required setting, for example to setting 5-7 for stews. set). See table for recommended switch settings. The piton light {on the left above the switch/Figure @ /1) will come or.
How to use the electronic timer Figure @1 24 hour digital display Figure®/2 Red indicator Eight comes on as soon 25 the knob is puled out Figure @/3 Nab for selecting symbols and setting times Figure /4 Red indicator lights — flash when a symbol Is selected and burn continuously as soon as you set the time on tha timer Figure @75 Cymbals The electronic timer displays not poly the exact them of day but car also be used for booting and frying: ™ Set times foy duration and end (for the automatic hotplates not
Example of sequence of sifting & program 1. Pocking time 2. Cooking finish 3. Switch for automatic hotplate T Select Select Set sg:" geode {shh fish Hotplate switches on { Set at 1115 Setting the alarm Mar Tire of day 1. Pauli out knob (Figure €9/3) 2, Turk knob clockwise o the symbol and 3. While the light above thé symbol is still flashing push the Knob in agrarian turn clockwise turtle the time of for example & minutes {0:05} appears on the display. To correct: turn clockwise or counter-clockwise.
Switching off the automatic hotplate(s) Basic principle You can turn the automatic hotplates off by using the automatic timer. in other words you set the cooking time and the automatic timer wilt automatically switch fhe hotplate off after the cooking time set has lapsed {for example after 45 minutes), Advantage: You can fave the dish to cook on its own. An audible signal reminds you that the dish is ready. The hotplate has switched off.
Switching the automatic hotplates on and off (per-selection) Basic principle You can turn the automatic hotplates on and off by using the automatic timer, In other words you set the cooking time and additionally the time at which the dish should be ready. The automatic dimer then switches on and off automatically. Example: you are heaving home at 9 a.m and want your funk to be ready at 12 mid You set the cooking time of for example Minutes and the time at which the food should be ready, 6. g.
Switching the automatic hotplates on and off (per-selection} . Checking the end of cooking time If you want ta know at what time your dish wilt be ready: ® pull the knob out and turn clockwise to e symbol {3 and W look af the time display. The time will be displayed for approximately 8 seconds. Then push the knob in again, You can check on the time remaining by means of the symbol IR Switching off The hotplate(s} will switch off automatically when the cooking time has lapsed.
Cleaning and care VITRIOLIC hobos {ceramist glass hobos) Ceramic sutures require regular care and cleaning Please follow the suggestions listed below: 1. Make sure that the cooking surface and the bases of the cooking utensils are CLEAN and DRY before use. ~ . Clean the VITRIOLIC hob after each use with a damp cloth and washing up Guided i Rinse with clean water and rub completely dry with a clean tea towel. Residues from cleaning materials will damage the hob surface. 3.
What (something doesn’t work) . the indicator lights do not come on W Check that you fave followed the operating instructions correctly. W Check that the fuses in the installation have not blown. . the indicator lights for time symbol and electronic timer (0:00) are Hashing 1. Before using for the first time the time of day must be set. Poly then wail the ‘hotplates function: Please ready “Before using for the thirst time™” on page 18. 2. Power failure, The times set have been canceled by the power failure.
important note On page 28 we have listed the most important malfunctions winch you can remedy yourself, 8 if however you call in & service mechanic for one of the malfunctions sifted or on account of incorrect opera. son, the visit of our service mechanic will not be free of charge even during the guarantee period. B For this reason we would ask you to carefully read through these operating instructions together with our additional recommendations and suggestions.