SANTO Tisch-Kühlautomat Réfrigérateur automatique table top Frigorifero tavolo D Gebrauchsanweisung F Mode d’emploi I Istruzioni per l’uso
Chère Cliente, Cher Client Avant de mettre votre nouvel appareil en marche, veuillez lire attentivement le présent mode d’emploi. Vous y trouverez des informations importantes sur la sécurité d’utilisation, l’installation et l’entretien de l’appareil. Conservez le mode d’emploi de manière à pouvoir le consulter par la suite. Remettez-le à un éventuel nouveau propriétaire de l’appareil. Ce mode d’emploi s’applique à plusieurs modèles techniquement comparables, qui diffèrent par leur équipement.
Contenu Sécurité . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 27 Elimination . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 29 Information sur l’emballage de l’appareil . . . . . . . . . . . . . . . . . . . . . . . . . . 29 Elimination des vieux appareils . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 29 Retrait de la protection pour le transport . . . . . . . . . . . . . . . . . . . .
Sécurité La sécurité de nos appareils est conforme aux règles reconnues de la technique et à la loi sur la sécurité des appareils. Nous nous voyons cependant obligés de vous familiariser avec les conseils de sécurité suivants: Utilisation conforme à la destination • L’appareil frigorifique est conçu pour une utilisation domestique. Il est adapté à la réfrigération, à la congélation de produits alimentaires, au stockage des aliments surgelés, ainsi qu’à la préparation de glaçons.
Sécurité • Veuillez rendre inutilisables les appareils arrivés en fin de vie avant de les éliminer. Enlever la fiche de la prise de courant, couper le cordon d’alimentation, enlever ou détruire les fermetures à coulisse ou à verrou éventuellement présentes. Vous évitez de la sorte que des enfants qui jouent puissent s’enfermer dans l’appareil (Danger de suffocation!) ne se mettent dans d’autres types de situation de danger mortel.
• Les appareils frigorifiques peuvent uniquement être réparés par des spécialistes. Des réparations incorrectes peuvent être source de dangers très graves. En cas de réparation, adressez–vous à votre revendeur spécialisé ou à notre service après–vente.
Retrait de la protection pour le transport L’appareil et certaines parties de l’équipement intérieur sont protégés pour le transport. 1. Enlevez les bandes autocollantes à gauche et à droite à l’extérieur de la porte. 2. Enlevez toutes les bandes autocollantes et rembourrages à l’intérieur de l’appareil (sauf la plaque signalétique). ☞ Installation Lieu d’installation L’appareil doit être placé dans un local bien ventilé et sec.
Installation Si l’appareil est placé à côté d’un autre réfrigérateur ou congélateur, une distance latérale de 5 cm est nécessaire pour éviter la formation de condensation sur les côtés des appareils. Votre réfrigérateur a besoin d’air Le groupe réfrigérant fonctionne sans entretien. La seule condition à observer réside dans une bonne ventilation et asération.
Installation Démontage du plan de travail Une fois le plan de travail retiré, l’appareil peut être encastré sous un plan de travail continu. Il faut pour cela procéder de la manière décrite: les vis à fentes en croix (F) à ☞1. Desserer droite et à gauche. 2. Soulever légèrement le plan de travail, le déplacer de 20 mm environ vers l’arrière et le retirer par la haut (G). Devisser les supports du plan de travail (H) et les conserver.
Installation Réversibilité de la porte La butée de porte peut être déplacée de la droite (position d’origine) à la gauche si le lieu d’installation le nécessite. Attention! Pendant le déplacement de la butée de porte, l’appareil ne doit pas être branché sur le secteur. Débrancher préalablement la fiche secteur. ☞1. Inclinez l’appareil vers l’arrière. 2. Retirez la charnière inférieure (1) à l’aide des vis (K). 3. Ouvrez légérement la porte et retirezla par le bas. 1 K AEG97 4.
Installation Réversibilité du portillon du compartiment congélateur 180° Branchement électrique Une prise de courant avec contact de terre installée réglementairement est nécessaire pour le raccordement électrique. Elle devrait être placée de façon à pouvoir retirer la fiche du câble d’alimentation. La protection électrique doit admettre un courant d’au moins 10 ampères.
Description de l’appareil Vue de l’appareil ➇ ➆ ➅ ➈ ➄ ➀ Compartiment à beurre/à fromage ➁ Balconnet avec étrier d’arrêt (pas dans tous les modèles) ➂ Balconnet ➃ Balconnet porte bouteilles ➄ Bac à légumes ➀ ➁ ➂ ➃ ➅ Clayettes ➆ Régulateur de température et interrupteur d’éclairage ➇ Compartiment congélateur (pour la conservation et la congélation) ➈ Plaque signalétique Avant la mise en service ☞ Nettoyer l’intérieur de l’appareil et tous les équipements avant la première mise en service (voir “Nettoyage
Mise en service et réglage de la température Le régulateur de température se trouve en haut à droite dans le compartiment de réfrigération. Il sert en même temps d’interrupteur MARCHE/ARRET. Position „0“ = arrêt Position „1“ = température intérieure la plus chaude Position „6“ = température intérieure la plus froide AEG62 ☞1. Branchez la fiche dans la prise de courant. 2. Régler la température souhaitée en tournant le régulateur de température. L'éclairage intérieur s'allume.
Température ambiante Position du bouton de réglage de température env. 16°C Plage autour de 2 env. 25°C Plage autour de 2 env. 32°C 2à3 env. 38°C 1à2 3. Si vous souhaitez une température plus élevée ou plus faible, tournez le régulateur de température sur un réglage plus chaud ou plus froid. Important! Une température ambiante élevée (p. ex.
Equipement intérieur Clayettes Selon le modèle votre appareil est équipé de clayette(s) à fil et/ou en verre. La surface de rangement en verre au-dessus du bac à légumes doit toujours rester dans cette position, afin que les fruits et légumes restent frais plus longtemps. Les autres clayettes sont réglables en hauteur: 1. Tirez la clayette vers l’avant jusqu’à ce qu’elle puisse basculée vers le bas ou vers le haut tout en la maintenant et retirez-la. 2.
Equipement intérieur Porte-bouteille (pas dans tous les modèles) Dans certains modèles, un support de bouteilles est placé dans le balconnet porte bouteilles. Il sert à empêcher les bouteilles de se renverser et peut être déplacé latéralement. Boîte variable (pas dans tous les modèles, réalisation variable suivant les modèles) Certains modèles sont équipés d'une boîte variable fixée sous un balconnet de porte et pouvant être déplacée latéralement.
Rangement correct Pour des raisons physiques, il existe des zones de températures différentes dans le compartiment réfrigérateur. La zone la plus froide se trouve sur la surface de rangement inférieure. Les zones plus chaudes sont la surface de rangement supérieure et les surfaces de rangement dans la porte. L’exemple cicontre indique à quel endroit du réfrigérateur se trouvent les zones de températures appropriées pour différents types d’aliments.
• Il faut observer absolument les dates limites de conservation indiquées par le fabricant. • Les aliments décongelés sans autre transformation (préparation de plats finis) ne doivent jamais être congelés une seconde fois. 1. Emballer hermétiquement tous les aliments avant de les congeler pour les empêcher de dessécher, de perdre leur goût et pour éviter que le goût ne soit transmis à d’autres aliments congelés. Attention ! Ne touchez pas les aliments surgelés avec des mains humides.
Dégivrage Le compartiment frigo dégivre automatiquement La paroi arrière du compartiment frigo se couvre de givre pendant le fonctionnement du compresseur et dégivre lorsque le compresseur est à l’arrêt. L’eau de dégivrage est recueillie dans la goulotte à l’arrière du compartiment frigo, est guidée à travers le trou d’écoulement dans une baccollecteur sur le compresseur, où elle s’évapore. Le trou d'écoulement de l'eau de dégivrage doit être nettoyé régulièrement (voir chapitre «Nettoyage et entretien»).
4. Retirer le bouchon de fermeture de l’évacuation de l’eau de dégivrage. Placer un bac-collecteur dessous afin de récupérer l’eau de dégivrage. Attention! Après le dégivrage, remettre le bouchon de fermeture dans le trou d'écoulement de l'eau de dégivrage. Conseil: Vous pouvez accélérer le processus de dégivrage en plaçant un récipient rempli d’eau chaude dans le compartiment surgélateur et en fermant ensuite les portes.
• Ne pas utiliser de produits de nettoyage abrasifs. 1. Enlever les aliments refroidis et surgelés. Envelopper les aliments surgelés dans plusieurs couches de papier journal. Entreposer le tout couvert dans un endroit frais. 2. Dégivrer le compartiment surgélateur avant le nettoyage (voir section "Dégivrage"). 3. Mettre l’appareil hors service et tirer le cordon d’alimentation de la prise ou débrancher/dévisser le fusible. 4.
• Ne pas régler la température plus bas que nécessaire. • Placer les aliments surgelés dans le compartiment réfrigérateur pour les dégeler. Le froid des aliments surgelés est ainsi utilisé pour le refroidissement du compartiment réfrigérateur. • Tenez bien prope le condenseur dégageant de la chaleur, la grille métallique sur la paroi arrière de votre appareil. Que faire si ...
Que faire si ... Dérangement Cause possible La température est mal réglée. Remède Veuillez consulter la partie "Mise en service". La porte est restée ouverte N’ouvrez pas la porte plus trop longtemps. longtemps que nécessaire. La température à l’intérieur de l’appareil est trop chaude. De trop grandes quantités Veuillez consulter la partie d’aliments ont été entre"Réglage de la températuposées au cours des dernière". res 24 heures.
Que faire si ... Dérangement Cause possible Remède Après modifié le réglage Le compresseur se met en de la température, le com- C’est normal, il n’y a aucumarche après quelques presseur ne se met pas en ne anomalie. instants automatiquement. marche. Remplacement de l’ampoule d’éclairage Attention! Danger d'électrocution! Avant de remplacer la lampe, débrancher l'appareil et tirer la fiche de la prise de courant ou débrancher ou retirer le fusible. Données de la lampe: 220-240 V, max. 15 W. 1.
Bruits de fonctionnement Les bruits suivants sont typiques des appareils frigorifiques: • Claquement On l’entend chaque fois que le compresseur se met en marche ou s’éteint. • Bourdonnement Dès que le compresseur se met en marche, vous l’entendrez bourdonner. • Circulation de liquide Il n’est pas anormal d’entendre le bruit de circulation du fluide frigorigène selon son état liquide, gazeux ou vaporeux.
Terminologie spécifique • Frigorigènes Les liquides employés pour la production de froid sont appelés frigorigènes. Ils ont un point d’ébullition relativement bas, si bas que la chaleur des aliments contenus dans l’appareil réfrigérant peut faire bouillir et évaporer le frigorigène. • Circuit frigorifique Système de circulation en circuit fermé dans lequel se trouve le frigorigène. Le circuit frigorifique se compose essentiellement de l’évaporateur, du compresseur, du condenseur ainsi que des tuyauteries.
AEG Hausgeräte GmbH Postfach 1036 D-90327 Nürnberg http://www.aeg.hausgeraete.