User manual

50
Prior to Initial Start–Up
Please clean the appliance interior and all accessories prior to initial
start-up (see section: “Cleaning and Care”).
Electrical Connection
The plug socket necessary for connection of your appliance to the
electricity supply should be positioned so that it is possible to pull out
the appliance plug.
☞
130
300
AEG44
If your appliance is installed under a
continuous worktop, the plug socket
should be provided as shown.
Alternatively a concealed spur socket
fitted with a 13 A fuse may be fitted.
If the socket is not accessible once
the appliance is built in, the electri-
cal installation must include suitable
means of isolating the appliance
from the mains (e.g. fuse, cut-out,
current trip or similar with a mini-
mum contact separation of 3 mm).
☞ Before initial start-up, refer to the appliance serial plate to ascertain if
supply voltage and current values correspond with those of the mains
at the installation location.
e.g.: AC 220 ... 240 V 50 Hz or
220 ... 240 V ~50 Hz
(i.e. 220 to 240 volts alternating current, 50 Hertz).
The rating plate is inside the appliance on the left.