User manual

8.1 Replacing the lamp
1.
Disconnect the mains plug from the
mains socket.
2.
Remove the screw from the lamp
cover.
3.
Remove the lamp cover (refer to the
illustration).
4.
Replace the used lamp with a new
lamp of the same power and specifi-
cally designed for household appli-
ances. (the maximum power is
shown on the lamp cover).
5.
Install the lamp cover.
6.
Tighten the screw to the lamp cover.
7.
Connect the mains plug to the mains
socket.
8.
Open the door. Make sure that the
lamp comes on.
8.2 Closing the door
1.
Clean the door gaskets.
2.
If necessary, adjust the door. Refer
to "Installation".
3.
If necessary, replace the defective
door gaskets. Contact the Service
Center.
9. INSTALLATION
WARNING!
Read the "Safety Information"
carefully for your safety and cor-
rect operation of the appliance
before installing the appliance.
9.1 Positioning
This appliance can be installed in a dry,
well ventilated indoor (garage or cellar)
also, but for optimum performance in-
stall this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:
Cli-
mate
class
Ambient temperature
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
ENGLISH 11