Operation Manual

ble regulations to obtain from
your local authorities. Avoid
damaging the cooling unit, espe-
cially at the rear near the heat ex-
changer. The materials used on
this appliance marked by the
symbol
are recyclable.
2. CONTROL PANEL
21
1
Pilot light
2
Temperature regulator
2.1 Switching on
Insert the plug into the wall socket.
Turn the Temperature setting regulator
clockwise to a medium setting.
The pilot light will light up.
2.2 Switching off
To turn off the appliance, turn the Tem-
perature regulator to the "O" position.
The pilot light will switch off.
2.3 Temperature regulation
The temperature is automatically regula-
ted.
To operate the appliance, proceed as
follows:
• turn the Temperature regulator to-
ward lower settings to obtain the mini-
mum coldness.
• turn the Temperature regulator to-
ward higher settings to obtain the
maximum coldness.
A medium setting is generally
the most suitable.
However, the exact setting should be
chosen keeping in mind that the temper-
ature inside the appliance depends on:
• room temperature
• how often the door is opened
• the quantity of food stored
• the location of the appliance.
If the ambient temperature is
high or the appliance is fully loa-
ded, and the appliance is set to
the lowest temperatures, it may
run continuously causing frost to
form on the rear wall. In this case
the dial must be set to a higher
temperature to allow automatic
defrosting and therefore reduced
energy consumption.
3. DAILY USE
3.1 Before first use
Before using the appliance for the first
time, wash the interior and all internal
accessories with lukewarm water and
some neutral soap so as to remove the
typical smell of a brand-new product,
then dry thoroughly.
Do not use detergents or abra-
sive powders, as these will dam-
age the finish.
ENGLISH 19