Operation Manual

If your appliance is still not working
properly after making the above checks,
contact the After Sales Centre.
7.1 Replacing the lamp
1
2
The appliance is equipped with a longlife
LED interior light.
1.
Disconnect the appliance.
2.
Push the movable part to unhook the
lamp cover (1).
3.
Remove the lamp cover (2).
4.
If needed replace the lamp with a
light of similar characteristic and pow-
er. It is suggested to use Osram PAR-
ATHOM SPECIAL T26 0.8 Watts.
5.
Install the lamp cover.
6.
Connect the appliance.
7.
Open the door. Make sure that the
lamp comes on.
7.2 Closing the door
1.
Clean the door gaskets.
2.
If necessary, adjust the door. Refer
to "Installation".
3.
If necessary, replace the defective
door gaskets. Contact the Service
Center.
8. INSTALLATION
WARNING!
Read the "Safety Information"
carefully for your safety and cor-
rect operation of the appliance
before installing the appliance.
8.1 Positioning
Install this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:
Cli-
mate
class
Ambient temperature
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
ENGLISH 33