S53520CTW2 EN User Manual
www.aeg.com CONTENTS 1. SAFETY INFORMATION.................................................................................................3 2. SAFETY INSTRUCTIONS................................................................................................ 4 3. PRODUCT DESCRIPTION.............................................................................................. 6 4. OPERATION...................................................................................................................
ENGLISH 1. 3 SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. 1.
www.aeg.com • • • • • • • Do not use water spray and steam to clean the appliance. Clean the appliance with a moist soft cloth. Only use neutral detergents. Do not use abrasive products, abrasive cleaning pads, solvents or metal objects. Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
ENGLISH installation. Make sure that there is access to the mains plug after the installation. • Do not pull the mains cable to disconnect the appliance. Always pull the mains plug. 2.3 Use WARNING! Risk of injury, burns, electrical shock or fire. • Do not change the specification of this appliance. • Do not put electrical appliances (e.g. ice cream makers) in the appliance unless they are stated applicable by the manufacturer. • Be careful not to cause damage to the refrigerant circuit.
www.aeg.com 3. PRODUCT DESCRIPTION 3.
ENGLISH 7 4. OPERATION 4.1 Control panel 1 1 Temperature indicators LED 2 FROSTMATIC 3 Temperature regulator 3 2 4.2 Switching on Insert the plug into the wall socket. 4.3 FROSTMATIC function You can activate FROSTMATIC function by pressing the FROSTMATIC button. The LED corresponding to the symbol FROSTMATIC indicator lights up. You can deactivate FROSTMATIC function by pressing the FROSTMATIC button again. The FROSTMATIC indicator will light off. This function stops automatically after 52 hours.
www.aeg.com rating plate, a label located on the inside of the appliance. The freezing process lasts 24 hours: during this period do not add other food to be frozen. When the freezing process is completed, return to the required temperature (see "FROSTMATIC Function"). 5.4 DYNAMICAIR function The DYNAMICAIR function let food cool quickly and a more constant temperature in the refrigerator. To activate the DYNAMICAIR device push the switch (1). The green indicator (2) comes on.
ENGLISH Do not move the lower door shelf to ensure correct air circulation. 5.6 Movable shelves The walls of the refrigerator are equipped with a series of shelves support so that the shelves can be positioned as desired. 9 5.8 Removal of freezing baskets from the freezer The freezing baskets have a limit stop to prevent their accidental removal or falling out.
www.aeg.com 6. HINTS AND TIPS 6.1 Normal operating sounds The following sounds are normal during operation: • A faint gurgling and bubbling sound from coils sound when refrigerant is pumped. • A whirring and pulsating sound from the compressor when refrigerant is pumped. • A sudden cracking noise from inside appliance caused by thermic dilatation (a natural and not dangerous physical phenomenon). • A faint click noise from the temperature regulator when the compressor switches on or off. 6.
ENGLISH • it is advisable to show the freezing in date on each individual pack to enable you to keep tab of the storage time. 6.
www.aeg.com 4. If accessible, clean the condenser and the compressor at the back of the appliance with a brush. This operation will improve the performance of the appliance and save electricity consumption. 7.5 Defrosting of the refrigerator Frost is automatically eliminated from the evaporator of the refrigerator compartment every time the motor compressor stops, during normal use.
ENGLISH Problem 13 Possible cause Solution There is no voltage in the mains socket. Connect a different electrical appliance to the mains socket. Contact a qualified electrician. The appliance is noisy. The appliance is not suppor- Check if the appliance ted properly. stands stable. The lamp does not work. The lamp is in stand-by. Close and open the door. The lamp does not work. The lamp is defective. Contact the nearest Authorized Service Centre. The compressor operates continually.
www.aeg.com Problem Possible cause Solution Temperature cannot be set. The FROSTMATIC or COOL- Switch off FROSTMATIC or MATIC function is switched COOLMATIC manually, or on. wait until the function resets automatically to set the temperature. Refer to "FROSTMATIC or COOLMATIC function". Door is misaligned or interferes with ventilation grill. The appliance is not levelled. The temperature in the appliance is too low/too high.
Ambient temperature N +16°C to + 32°C ST +16°C to + 38°C T +16°C to + 43°C Some functional problems might occur for some types of models when operating outside of that range. The correct operation can only be guaranteed within the specified temperature range. If you have any doubts regarding where to install the appliance, please turn to the vendor, to our customer service or to the nearest Service Centre 9.
www.aeg.com As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: 1. Connect the wire coloured green and yellow to the terminal marked either with the letter “E“ or by the earth symbol or coloured green and yellow. 2. Connect the wire coloured blue to the terminal either marked with the letter “N“ or coloured black. 3.
ENGLISH 3. Remove the door from the middle hinge pivot (2). 4. Place the cover of the upper hinge into the holes on the opposite side. 5. Screw off the screws of the middle hinge (3). 6. Remove the plugs on the upper side of both doors and move them to the other side. 7. Remove the lower door from the lower hinge pivot (4). 17 7 8 3 4 12. Place the lower door on the lower hinge pivot (9). 13. Screw off the middle cover plugs and screw them into the hole on the opposite side (10). 14.
www.aeg.com Do a final check to make sure that: • All screws are tightened. • The magnetic seal adheres to the cabinet. • The door opens and closes correctly. If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket. In case you do not want to carry out the above mentioned operations, contact the nearest After Sales Service Force.
ENGLISH The technical information are situated in the rating plate, on the external or internal side of the appliance and in the energy label. 11. ENVIRONMENTAL CONCERNS Recycle the materials with the symbol . Put the packaging in applicable containers to recycle it. Help protect the environment and human health and to recycle waste of electrical and electronic appliances. Do not dispose appliances marked with the symbol with the household waste.
280152978-A-512013 www.aeg.
