EN User Manual Fridge Freezer S53630CSW2
www.aeg.com CONTENTS 1. SAFETY INFORMATION.................................................................................................3 2. SAFETY INSTRUCTIONS................................................................................................ 4 3. PRODUCT DESCRIPTION.............................................................................................. 6 4. OPERATION...................................................................................................................
ENGLISH 1. 3 SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. 1.
www.aeg.com • • • • • • • Do not use water spray and steam to clean the appliance. Clean the appliance with a moist soft cloth. Only use neutral detergents. Do not use abrasive products, abrasive cleaning pads, solvents or metal objects. Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
ENGLISH installation. Make sure that there is access to the mains plug after the installation. • Do not pull the mains cable to disconnect the appliance. Always pull the mains plug. 2.3 Use WARNING! Risk of injury, burns, electrical shock or fire. • Do not change the specification of this appliance. • Do not put electrical appliances (e.g. ice cream makers) in the appliance unless they are stated applicable by the manufacturer. • Be careful not to cause damage to the refrigerant circuit.
www.aeg.com 3. PRODUCT DESCRIPTION 3.1 Product overview 1 2 3 4 8 1 2 3 4 5 Vegetable drawers Cabinet shelves Bottle rack Control panel Door shelves 5 6 7 6 Bottle shelf 7 Freezer baskets 8 Rating plate 4. OPERATION 4.1 Switching on 4.3 Temperature regulation Insert the electrical plug into a wall socket. The temperature is automatically regulated. Turn the temperature regulator clockwise to a medium setting.
ENGLISH A medium setting is generally the most suitable. However, the exact setting should be chosen keeping in mind that the temperature inside the appliance depends on: • room temperature • how often the lid is opened • the quantity of food stored • the location of the appliance. 7 If the ambient temperature is high or the appliance is fully loaded, and the appliance is set to the lowest temperature, it may run continuously causing frost to form on the rear wall.
www.aeg.com 5.4 Positioning the door shelves To permit storage of food packages of various sizes, the door shelves can be placed at different heights. 5.6 Bottle rack Place the bottles (with the opening facing front) in the pre-positioned shelf. Place only closed bottles. 1. Gradually pull the shelf in the direction of the arrows until it comes free. 2. Reposition as required. 1 2 Do not move the lower door shelf to ensure correct air circulation. 5.
ENGLISH 2 9 At the time of putting it back, slightly lift the front of the basket to insert it into the freezer. Once you are over the end points, push the baskets back in their position. 1 6. HINTS AND TIPS 6.1 Normal operating sounds The following sounds are normal during operation: • A faint gurgling and bubbling sound from coils sound when refrigerant is pumped. • A whirring and pulsating sound from the compressor when refrigerant is pumped.
www.aeg.com • the maximum quantity of food which can be frozen in 24 hrs. is shown on the rating plate; • the freezing process takes 24 hours.
ENGLISH 11 CAUTION! Do not use detergents or abrasive powders, as these will damage the finish. 7.4 Periodic cleaning CAUTION! Do not pull, move or damage any pipes and/or cables inside the cabinet. CAUTION! Take care of not to damage the cooling system. CAUTION! When moving the cabinet, lift it by the front edge to avoid scratching the floor. The equipment has to be cleaned regularly: 1. Clean the inside and accessories with lukewarm water and some neutral soap. 2.
www.aeg.com a basin underneath to collect the defrost water. 7.7 Periods of non-operation When the appliance is not in use for long periods, take the following precautions: 1. Disconnect the appliance from electricity supply. 2. Remove all food. 3. Defrost (if necessary) and clean the appliance and all accessories. 4. Clean the appliance and all accessories. 5. Leave the door/doors open to prevent unpleasant smells.
ENGLISH 13 Problem Possible cause Solution The compressor operates continually. Temperature is set incorrectly. Refer to "Operation" chapter. Many food products were put in at the same time. Wait some hours and then check the temperature again. The room temperature is too high. Refer to climate class chart on the rating plate. Food products placed in the appliance were too warm. Allow food products to cool to room temperature before storing.
www.aeg.com Problem Possible cause Solution The food products' temperature is too high. Let the food products temperature decrease to room temperature before storage. Many food products are stored at the same time. Store less food products at the same time. The thickness of the frost is Defrost the appliance. greater than 4-5 mm. The door has been opened often. Open the door only if necessary. There is no cold air circula- Make sure that there is cold air tion in the appliance.
ENGLISH Some functional problems might occur for some types of models when operating outside of that range. The correct operation can only be guaranteed within the specified temperature range. If you have any doubts regarding where to install the appliance, please turn to the vendor, to our customer service or to the nearest Service Centre 9.2 Location 100 mm min The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc.
www.aeg.com symbol or coloured green and yellow. 2. Connect the wire coloured blue to the terminal either marked with the letter “N“ or coloured black. 3. Connect the wire coloured brown to the terminal either marked with the “L“ or coloured red. 4. Check that no cut, or stray strands of wire is present and the cord clamp (E) is secure over the outer sheath. Make sure the electricity supply voltage is the same as that indicated on the appliance rating plate. 5. Switch on the appliance.
ENGLISH 17 1 6 2 5 3. Remove the door from the middle hinge pivot (2). 4. Place the cover of the upper hinge into the holes on the opposite side. 5. Screw off the screws of the middle hinge (3). 6. Remove the plugs on the upper side of both doors and move them to the other side. 7. Remove the lower door from the lower hinge pivot (4). 3 9. Screw off the screws of the lower hinge and remove the hinge (8). 10. Screw off the lower cover plugs and screw them into the hole on the opposite side (7). 11.
www.aeg.com C 10 B A 180 C o B 11 9 A 15. Place the upper door on the middle hinge pivot (12). 16. Fix the door with upper hinge and fix it with screws of it (13). 13 12 17. Attach the door handles and plugs on the opposite side. Do a final check to make sure that: • All screws are tightened. • The magnetic seal adheres to the cabinet. • The door opens and closes correctly. If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet.
ENGLISH The technical information are situated in the rating plate, on the external or internal side of the appliance and in the energy label. 11. ENVIRONMENTAL CONCERNS Recycle the materials with the symbol . Put the packaging in applicable containers to recycle it. Help protect the environment and human health and to recycle waste of electrical and electronic appliances. Do not dispose appliances marked with the symbol with the household waste.
280153125-B-152014 www.aeg.
