User Manual

Problem Possible cause Solution
Water flows on the
ground.
The melting water outlet
does not flow in the evap-
orative tray above the
compressor.
Attach the melting water
outlet to the evaporative
tray.
The temperature in
the appliance is too
low/high.
The temperature regulator
is not set correctly.
Set a higher/lower temper-
ature.
If your appliance is still not working prop-
erly after making the above checks, con-
tact the After Sales Centre. You can find
the list at the end of this manual.
REPLACING THE CONTROL
UNIT
The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the con-
trol unit. Contact your Service Center.
CLOSING THE DOOR
1.
Clean the door gaskets.
2.
If necessary, replace the defective
door gaskets. Contact the After Sales
Service.
16
www.aeg.com