S74000KMXL EN User manual
www.aeg.com CONTENTS 1. 2. 3. 4. 5. 6. 7. 8. 9. SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 PRODUCT DESCRIPTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 CONTROL PANEL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 DAILY USE . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
ENGLISH 1. 3 SAFETY INSTRUCTIONS In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features.
www.aeg.com 1. • • • • Power cord must not be lengthened. 2. Make sure that the power plug is not squashed or damaged by the back of the appliance. A squashed or damaged power plug may overheat and cause a fire. 3. Make sure that you can come to the mains plug of the appliance. 4. Do not pull the mains cable. 5. If the power plug socket is loose, do not insert the power plug. There is a risk of electric shock or fire. 6.
ENGLISH 1.6 Service • Any electrical work required to do the servicing of the appliance should be carried out by a qualified electrician or competent person. • Do not remove the LED light cover. Contact the nearest After Sales Service Force to replace the LED light board, if it is necessary. • This product must be serviced by an authorized Service Centre, and only genuine spare parts must be used. 1.7 Environment Protection ozone layer, in either its refrigerant circuit or insulation materials.
www.aeg.com 11 Clean Air Control 3. CONTROL PANEL 1 2 7 3 6 4 5 1 ON/OFF button 2 Alarm reset button 3 OK button 4 Temperature warmer button 5 Display 6 Temperature colder button 7 Mode button It is possible to change predefined sound of buttons to a loudly one by pressing together Mode button and Temperature colder button for some seconds. Change is reversible. 3.
ENGLISH The set temperature will be reached within 24 hours. After a power failure the set temperature remains stored. 3.5 Minute Minder function The Minute Minder function is to be used to set an acoustic alarm at the preferred time, useful for example when a recipe requires to cool down a mixture for a certain length of time. To switch on the function: 1. Press the Mode button until the corresponding icon appears. The Minute Minder indicator flashes.
www.aeg.com 3.9 Holiday function This function allows you to keep the refrigerator closed and empty during a long holiday period without the formation of a bad smell. The fridge compartment must be empty with holiday function on. To switch on the function: 1. Press the Mode button until the corresponding icon appears. The Holiday indicator flashes. The fridge temperature indicator shows the set temperature. 2. Press the OK button to confirm. The Holiday indicator is shown. To switch off the function: 1.
ENGLISH 9 4.4 MaxiBox drawer The drawer is suitable for storing fruit and vegetables. 5. HELPFUL HINTS AND TIPS 5.1 Normal Operating Sounds • You may hear a faint gurgling and a bubbling sound when the refrigerant is pumped through the coils or tubing. This is correct. • When the compressor is on, the refrigerant is being pumped around and you will hear a whirring sound and a pulsating noise from the compressor. This is correct. • The thermic dilatation might cause a sudden cracking noise.
www.aeg.com Meat (all types) : wrap in polythene bags and place on the glass shelf above the vegetable drawer. For safety, store in this way only one or two days at the most. Cooked foods, cold dishes, etc.: these should be covered and may be placed on any shelf. Fruits and vegetables: these should be thoroughly cleaned and placed in the special drawer(s) provided. When in contact, lemon juice can discolor the plastic parts of your fridge.
ENGLISH the refrigerator compartment channel to prevent the water overflowing and dripping onto the food inside. Use the special cleaner provided, which you will find already inserted into the drain hole. 11 6.4 Replacing the carbon filter To get best performance the carbon air filter should be changed once every year. New active air filters can be purchased from your local dealer. Refer to “Installation of the carbon air filter” for the instructions.
www.aeg.com Problem Possible cause Solution “dEMo” appears on the display. The appliance is in demonstration mode. Keep pressed approximately 10 sec the OK button since a long sound of buzzer is heard and the display shut off for a short while: appliance start works regularly. The compressor runs The Temperature regula- Set a warmer temperature. continuously. tor may be set incorrectly. Water flows inside the refrigerator. The door is not closed correctly. Refer to "Closing the door".
ENGLISH Problem Possible cause The appliance does not operate. The appliance is switched Switch on the appliance. off. 13 Solution The mains plug is not connected to the mains socket correctly. Connect the mains plug to the mains socket correctly. The appliance has no power. There is no voltage in the mains socket. Connect a another electrical appliance to the mains socket. Check fuse. Contact a qualified electrician. The lamp is defective. Refer to "Replacing the lamp".
www.aeg.com 8.2 Location 100 mm min The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc. Ensure that air can circulate freely around the back of the cabinet. To ensure best performance, if the appliance is positioned below an overhanging wall unit, the minimum distance between the top of the cabinet and the wall unit must be at least 100 mm . Ideally, however, the appliance should not be positioned below overhanging wall units.
ENGLISH 8.5 Electrical Connection A 15 B CAUTION! Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. WARNING! This appliance must be earthed. The manufacturer declines any liability should these safety measures not be observed.
www.aeg.com • Insert the filter in the slot found in the back of the air lever flap. • Close the air lever flap. The filter should be handled carefully so fragments do not loosen from the surface. Make sure that the air lever flap is closed to obtain proper function. 8.8 Door reversibility WARNING! Before carrying out any operations, remove the plug from the power socket. 1 2 WARNING! Make sure that the appliance is electrically not powered.
ENGLISH 17 • Remove the door end cap cover. • Take out the cable from the door end cap and place it into the upper hinge. • Connect the cable to the connecting point in the front panel to the corresponding side. • Put back the hinge cover and the top front covers. • Place the display cable, which is currently disconnected, into the cable holder in the door end cap. • Put back the door end cap covers. (2) 1 2 A E B F C D • Remove the cover with the help of a tool (A).
www.aeg.com 3 1 2 5 4 6 • Remove the handle. Unscrew the top handle bracket from the handle rod (1). • Unscrew the bottom handle bracket from the door .(2) • Remove the handle. • Unscrew the top handle bracket from the door (3). • Re-screw the handle bracket on the door (4). • Turn the handle bracket with the handle and screw them to the door (5) and the fitted handle bracket (6). • Do a final check to make sure that: • All screws are tightened. • The magnetic seal adheres to the cabinet.
ENGLISH 10. ENVIRONMENT CONCERNS Recycle the materials with the symbol . Put the packaging in applicable containers to recycle it. Help protect the environment and human health and to recycle waste of electrical and electronic appliances. Do not dispose appliances marked with the symbol with the household waste. Return the product to your local recycling facility or contact your municipal office.
280152571-A-392013 www.aeg.