S74100DTX0 EN User manual
www.aeg.com CONTENTS 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. SAFETY INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 CONTROL PANEL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 DAILY USE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 HELPFUL HINTS AND TIPS . . . . . . . . . . . . . .
ENGLISH 1. 3 SAFETY INFORMATION In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features.
www.aeg.com 2. • • • • Make sure that the power plug is not squashed or damaged by the back of the appliance. A squashed or damaged power plug may overheat and cause a fire. 3. Make sure that you can come to the mains plug of the appliance. 4. Do not pull the mains cable. 5. If the power plug socket is loose, do not insert the power plug. There is a risk of electric shock or fire. 6. You must not operate the appliance without the lamp cover (if foreseen) of interior lighting. This appliance is heavy.
ENGLISH 5 ant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish. The insulation foam contains flammable gases: the appliance shall be disposed according to the applicable regulations to obtain from your local authorities. Avoid damaging the cooling unit, especially at the rear near the heat exchanger. The materials used on this appliance marked by the are recyclable. symbol 1.
www.aeg.com 2.4 Frostmatic function You can activate the Frostmatic function by pressing the Frostmatic button more times until the LED corresponding to the symbol Frostmatic indicator lights up. To deactivate the Frostmatic function, press more times the Frostmatic button until the required temperature is selected. 3. DAILY USE 3.
ENGLISH 7 3.4 Vegetable drawer with humidity control The drawer is suitable for storing fruit and vegetables. Place the separator inside the drawer in different positions to allow for the subdivision best suited to personal needs. The grille (if foreseen) on the bottom of the drawer separates the fruit and vegetables from any humidity that may form on the bottom surface. Remove all parts inside the drawer for cleaning purposes.
www.aeg.com Switch on the fan when the ambient temperature exceeds 25°C. 3.8 Using of the Twist&Serve ice maker This appliance is equipped with one or more trays for the production and the storage of ice-cubes. Twist&Serve ice maker is positioning in the freezer compartment under the shelf. It consists of a double tray ice dispenser and of an ice box. It is possible to shift the Ice Dispenser on left or on right according to your space needs.
ENGLISH 9 4. HELPFUL HINTS AND TIPS 4.1 Hints for energy saving 4.4 Hints for freezing • Do not open the door frequently or leave it open longer than absolutely necessary. • If the ambient temperature is high and the Temperature Regulator is set to low temperature and the appliance is fully loaded, the compressor may run continuously, causing frost or ice on the evaporator.
www.aeg.com • do not exceed the storage period indicated by the food manufacturer. 5. CARE AND CLEANING CAUTION! Unplug the appliance before carrying out any maintenance operation. This appliance contains hydrocarbons in its cooling unit; maintenance and recharging must therefore only be carried out by authorized technicians. 5.1 Periodic cleaning The equipment has to be cleaned regularly: • clean the inside and accessories with lukewarm water and some neutral soap.
ENGLISH 11 5.3 Defrosting of the refrigerator Frost is automatically eliminated from the evaporator of the refrigerator compartment every time the motor compressor stops, during normal use. The defrost water drains out through a trough into a special container at the back of the appliance, over the motor compressor, where it evaporates. Periodically clean the defrost water drain hole in the middle of the refrigerator compartment channel to prevent the water overflowing and dripping onto the food inside.
www.aeg.com Problem Possible cause Solution The mains plug is not connected to the mains socket correctly. Connect the mains plug to the mains socket correctly. The appliance has no power. There is no voltage in the mains socket. Connect a different electrical appliance to the mains socket. Contact a qualified electrician. The lamp is in stand-by. Close and open the door. The lamp is defective. Refer to "Replacing the lamp". The temperature is not set correctly. Set a higher temperature.
ENGLISH 13 Problem Possible cause Solution The temperature in the refrigerator is too high. There is no cold air circulation in the appliance. Make sure that there is cold air circulation in the appliance. The temperature in the freezer is too high. Products are too near to each other. Store products so that there is cold air circulation. 6.1 Replacing the lamp CAUTION! Disconnect the plug from the mains socket. Remove the screw from the lamp cover.
www.aeg.com 7.2 Location 100 mm A B 10 mm 10 mm The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc. Ensure that air can circulate freely around the back of the cabinet. To ensure best performance, if the appliance is positioned below an overhanging wall unit, the minimum distance between the top of the cabinet and the wall unit must be at least 100 mm . Ideally, however, the appliance should not be positioned below overhanging wall units.
ENGLISH 6. Switch on the appliance. The appliance is supplied with a 13 amp plug fitted B. In the event of having to change the fuse in the plug supplied, a 13 amp ASTA approved (BS 1362) fuse must be used. 15 WARNING! A cut off plug inserted into a 13 amp socket is a serious safety (shock) hazard. Ensure that it is disposed of safely. 7.4 Rear spacers Inside the appliance you find two spacers which must be fitted as shown in the figure.
www.aeg.com H Unscrew the middle hinge (H). Unscrew the plastic plugs located on the opposite side of the middle hinge and introduce them in the holes left free from the removed hinge. Remove the lower door. Remove the ventilation grille which is fixed by two screws. Carefully place the appliance on its back, totally unscrew the adjustable foot and screw it in the opposite side. Remove the bottom hinge by unscrewing its fixing screws.
ENGLISH h1 h2 h3 h4 h5 h6 Do a final check to make sure that: • All screws are tightened. • The magnetic seal adheres to the cabinet. • The door opens and closes correctly. If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket. 8. NOISES There are some sounds during normal running (compressor, refrigerant circulation). 17 Remove the handle.
www.aeg.
ENGLISH 9. TECHNICAL DATA Dimension of the recess Height 1800 mm Width 695 mm Depth 696 mm Rising Time 20 h Voltage 230-240 V Frequency 50 Hz The technical information are situated in the rating plate on the internal left side of the appliance and in the energy label. 10. ENVIRONMENT CONCERNS Recycle the materials with the symbol . Put the packaging in applicable containers to recycle it.
222344687-A-172012 www.aeg.