S83200CMW0 EN User manual
www.aeg.com CONTENTS 1. 2. 3. 4. 5. 6. 7. 8. SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 CONTROL PANEL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 FIRST USE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 HELPFUL HINTS AND TIPS . . . . . . . . . . . . . . . .
ENGLISH 1. 3 SAFETY INSTRUCTIONS In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features.
www.aeg.com WARNING! Any electrical component (power cord, plug, compressor) must be replaced by a certified service agent or qualified service personnel to avoid hazard. 1. • • • • Power cord must not be lengthened. 2. Make sure that the power plug is not squashed or damaged by the back of the appliance. A squashed or damaged power plug may overheat and cause a fire. 3. Make sure that you can come to the mains plug of the appliance. 4. Do not pull the mains cable. 5.
ENGLISH • The appliance must not be located close to radiators or cookers. • Make sure that the mains plug is accessible after the installation of the appliance. • Connect to potable water supply only (If a water connection is foreseen). 5 1.7 Environment Protection This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish.
www.aeg.com 10 Child Lock function 2.2 Switching on To switch on the appliance do these steps: 1. Connect the mains plug to the power socket. 2. Press the appliance ON/OFF button if the display is off. 3. The alarm buzzer may sound after a few seconds. To reset the alarm refer to "High temperature alarm". 4. If "dEMo" appears on the display, the appliance is in demonstration mode. Refer to "Troubleshooting...". 5. The temperature indicators show the set default temperature.
ENGLISH 3. The Extra Humidity indicator goes off. 2.9 COOLMATIC function If you need to insert a large amount of warm food, for example after doing the grocery shopping, we suggest activating the COOLMATIC function to chill the products more rapidly and to avoid warming the other food which is already in the refrigerator. To switch on the function: 1. Press the Mode button until the corresponding icon appears. The COOLMATIC indicator flashes. 2. Press the OK button to confirm.
www.aeg.com • sounding of buzzer. To reset the alarm: 1. Press any button. 2. The buzzer switches off. 3. The freezer temperature indicator shows the highest temperature reached for a few seconds. Then show again the set temperature. 4. The alarm indicator continue to flash until the normal conditions are restored. When the alarm has returned the alarm indicator goes off. 2.13 Door open alarm An acoustic alarm will sound if the fridge door is left open for a few minutes.
ENGLISH Cooked foods, cold dishes, etc.: these should be covered and may be placed on any shelf. Fruits and vegetables: these should be thoroughly cleaned and placed in the special drawer(s) provided. When in contact, lemon juice can discolor the plastic parts of your fridge. It is therefore recommended to keep citruses in separate containers. Butter and cheese: these should be placed in special airtight containers or wrapped in aluminium foil or polythene bags to exclude as much air as possible.
www.aeg.com Do not pull, move or damage any pipes and/or cables inside the cabinet. Never use detergents, abrasive powders, highly perfumed cleaning products or wax polishes to clean the interior as this will damage the surface and leave a strong odour. Clean the condenser (black grill) and the compressor at the back of the appliance with a brush. This operation will improve the performance of the appliance and save electricity consumption. Take care of not to damage the cooling system.
ENGLISH 11 Problem Possible cause Solution The appliance is noisy. The appliance is not supported properly. Check if the appliance stands stable (all the four feet should be on the floor). The compressor operates continually. The Temperature regula- Set a warmer temperature. tor may be set incorrectly. The door is not closed correctly. Refer to "Closing the door". The door has been opened too frequently. Do not keep the door open longer than necessary. The product temperature is too high.
www.aeg.com Problem Possible cause Solution The product temperature is too high. Let the product temperature decrease to room temperature before storage. Many products are stored Store less products at the at the same time. same time. The temperature in the refrigeration is too high. There is no cold air circulation in the appliance. Make sure that there is cold air circulation in the appliance. The temperature in the freezer is too high. Products are too near to each other.
ENGLISH 13 7. TECHNICAL DATA Dimension Height 1850 mm Width 595 mm Depth 658 mm Rising Time 18 h Voltage 230 - 240 V Frequency 50 Hz The technical information are situated in the rating plate on the internal left side of the appliance and in the energy label. 8. INSTALLATION 8.2 Location 100 mm min WARNING! Read the "Safety Information" carefully for your safety and correct operation of the appliance before installing the appliance. 8.
www.aeg.com WARNING! It must be possible to disconnect the appliance from the mains power supply; the plug must therefore be easily accessible after installation. 8.5 Levelling 8.3 Electrical connection Before plugging in, ensure that the voltage and frequency shown on the rating plate correspond to your domestic power supply. The appliance must be earthed. The power supply cable plug is provided with a contact for this purpose.
ENGLISH 8.7 Installation of the CleanAir Control filter 15 characteristics. The filter should be placed behind the flap before the appliance is turned on. 1. Open the flap cover. 2. Remove the filter from the plastic bag. 3. Insert the filter in the slot found in the back of the flap cover. 4. Close the flap cover. The filter should be handled carefully so fragments do not loosen from the surface. The filter should change once every six months.
280152180-A-282013 www.aeg.
