EN User Manual Fridge Freezer S83430CTX2
www.aeg.com CONTENTS 1. SAFETY INFORMATION.................................................................................................3 2. SAFETY INSTRUCTIONS................................................................................................ 4 3. PRODUCT DESCRIPTION.............................................................................................. 6 4. OPERATION...................................................................................................................
ENGLISH 1. 3 SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. 1.
www.aeg.com • • • • Do not use water spray and steam to clean the appliance. Clean the appliance with a moist soft cloth. Only use neutral detergents. Do not use abrasive products, abrasive cleaning pads, solvents or metal objects. Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. 2.
ENGLISH 2.3 Use WARNING! Risk of injury, burns, electrical shock or fire. • Do not change the specification of this appliance. • Do not put electrical appliances (e.g. ice cream makers) in the appliance unless they are stated applicable by the manufacturer. • Be careful not to cause damage to the refrigerant circuit. It contains isobutane (R600a), a natural gas with a high level of environmental compatibility. This gas is flammable.
www.aeg.com 3. PRODUCT DESCRIPTION 3.
ENGLISH 7 4. OPERATION 4.1 Control panel 1 2 3 4 1 ON/OFF button 2 Top compartment temperature colder button 3 Top compartment temperature warmer button 4 Mode button 5 OK button 6 Bottom compartment temperature colder button 5 6 7 8 7 Bottom compartment temperature warmer button 8 Display It is possible to change predefined sound of buttons by pressing together Mode button and Temperature colder button for some seconds. Change is reversible.
www.aeg.com 4.3 Switching off 4.7 High temperature alarm 1. Press the appliance ON/OFF button for a few seconds. The display switches off. 2. Disconnect the mains plug from the power socket. An increase in the temperature in the freezer compartment (for example due to an earlier power failure or door is open) is indicated by: • flashing the alarm and freezer temperature indicators; • sounding of buzzer. 4.
ENGLISH The FROSTMATIC function shuts off automatically after 52 hours. To switch off the function before its automatic end, repeat the steps until the FROSTMATIC indicator goes off. 4.10 DYNAMICAIR function 1. Press Mode until the corresponding icon appears. The DYNAMICAIR indicator flashes. 2. Press OK to confirm. The DYNAMICAIR indicator is shown. The activation of the DYNAMICAIR function increases energy consumption.
www.aeg.com 5.1 Initial power on CAUTION! Before inserting the power plug in to the outlet and switching on the cabinet for the first time, leave the appliance standing upright for at least 4 hours. This will assure a sufficient amount of time for the oil to return to the compressor. Otherwise the compressor or electronic components may sustain damage. 5.
ENGLISH temperature, depending on the time available for this operation. 11 5.8 FreshBox drawer Small pieces may even be cooked still frozen, directly from the freezer: in this case, cooking will take longer. 5.6 Movable shelves The walls of the refrigerator are equipped with a series of runners so that the safety glass shelves can be positioned as desired. The drawer is suitable for storing fresh food like fish, meat, seafood, because the temperature is lower here than in the rest of the fridge.
www.aeg.com To make these adjustments proceed as follows: 1. Gradually pull in the direction of the arrows until it comes free. To switch on the device manually, refer to DYNAMICAIR mode. The DYNAMICAIR device stops when the door is open and restarts immediately after the door closing. 5.11 Carbon Air Filter Your appliance is equipped with a carbon filter CLEANAIR CONTROL in a drawer in the rear wall of the fridge compartment.
ENGLISH 13 6. HINTS AND TIPS 6.1 Normal operating sounds • A faint gurgling and bubbling sound from coils sound when refrigerant is pumped. • A whirring and pulsating sound from the compressor when refrigerant is pumped. • A sudden cracking noise from inside appliance caused by thermic dilatation (a natural and not dangerous physical phenomenon). • A faint click noise from the temperature regulator when the compressor switches on or off. • Cooked foods, cold dishes, etc..
www.aeg.com enable you to keep tab of the storage time. 6.
ENGLISH To make sure fully functionality of the FreshBox compartment the lowest shelf and cover plates must be put back in their original position after cleaning. frost when it is in operation, neither on the internal walls nor on the foods. The absence of frost is due to the continuous circulation of cold air inside the compartment, driven by an automatically controlled fan. The cover plates above the drawers in the compartment can be taken out for cleaning. 7.6 Periods of non-operation 7.
www.aeg.com 8.1 What to do if... Problem Possible cause Solution The appliance does not operate. The appliance is switched off. Switch on the appliance. The mains plug is not con- Connect the mains plug to the nected to the mains socket mains socket correctly. correctly. The appliance is noisy. There is no voltage in the mains socket. Connect a different electrical appliance to the mains socket. Contact a qualified electrician. The appliance is not supported properly.
ENGLISH Problem Possible cause 17 Solution The FROSTMATIC function Refer to "FROSTMATIC funcis switched on. tion". The COOLMATIC function Refer to "COOLMATIC funcis switched on. tion". The compressor does not start immediately after pressing the FROSTMATIC, or after changing the temperature. This is normal, no error has The compressor starts after a occurred. period of time. The compressor does not start immediately after pressing the COOLMATIC, or after changing the temperature.
www.aeg.com Problem Possible cause Solution The food products' temperature is too high. Let the food products temperature decrease to room temperature before storage. Many food products are stored at the same time. Store less food products at the same time. The door has been opened often. Open the door only if necessary. The FROSTMATIC function Refer to "FROSTMATIC funcis switched on. tion". The COOLMATIC function Refer to "COOLMATIC funcis switched on. tion".
ENGLISH 9.2 Electrical connection • Before plugging in, ensure that the voltage and frequency shown on the rating plate correspond to your domestic power supply. • The appliance must be earthed. The power supply cable plug is provided with a contact for this purpose. If the domestic power supply socket is not earthed, connect the appliance to a separate earth in compliance with current regulations, consulting a qualified electrician.
www.aeg.com aroma for all foodstuffs without risk of odor cross contamination. On delivery the carbon filter is in a plastic bag to preserve performance. The filter should be placed in the drawer before the appliance is turned on. 1. 2. 3. 4. Open the drawer. Take the filter out of the plastic bag. Insert the filter in the drawer. Close the drawer.
ENGLISH 1 2 1 2 4 3 3 6. Remove the spacer and middle hinge from the appliance, then carefully remove the bottom door. 9. Install the bottom hinge bracket on the opposite side of the appliance. Remember to attach the bottom hinge spacer. 10. Install the bottom door on the bottom hinge, and secure it by attaching the middle hinge to the appliance. Remember to attach the middle hinge spacer. 1 2 7. Remove the bottom hinge spacer then unscrew the bottom hinge bracket. 8.
www.aeg.com 2 2 1 1 3 12. Install the top hinge on the opposite side of the appliance, then replace all top hinge covers. 15. Reposition the top door cap and insert all plugs. 2 2 1 1 16. Unscrew the lower door stopper and then install it on the opposite side 2 3 13. Carefully position the top door on the middle hinge, then continue to fit the door onto the top hinge. 14. Secure the top door to the top hinge. 17. Unscrew the handles then handle brackets.
ENGLISH h1 h2 Do a final check to make sure that: • All screws are tightened. • The magnetic seal adheres to the cabinet. • The door opens and closes correctly. If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket. In case you do not want to carry out the above mentioned operations, contact the nearest After Sales Service Force.
280153437-A-182014 www.aeg.
