6 &70 (1 8VHU 0DQXDO
FOR PERFECT RESULTS Thank you for choosing this AEG product. We have created it to give you impeccable performance for many years, with innovative technologies that help make life simpler – features you might not find on ordinary appliances. Please spend a few minutes reading to get the very best from it. ACCESSORIES AND CONSUMABLES In the AEG webshop, you’ll find everything you need to keep all your AEG appliances looking spotless and working perfectly.
Contents 3 CONTENTS 4 6 11 12 15 16 18 20 20 25 Safety information Control panel First use Daily use Helpful hints and tips Care and cleaning What to do if… Technical data Installation Environmental concerns The following symbols are used in this user manual: Important information concerning your personal safety and information on how to avoid damaging the appliance.
Safety information SAFETY INFORMATION In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features.
Safety information 5 • It is dangerous to alter the specifications or modify this product in any way. Any damage to the cord may cause a short circuit, fire and/or electric shock. WARNING! Any electrical component (power cord, plug, compressor) must be replaced by a certified service agent or qualified service personnel to avoid hazard. • • • • 1. Power cord must not be lengthened. 2. Make sure that the power plug is not squashed or damaged by the back of the appliance.
Control panel Installation For electrical connection carefully follow the instructions given in specific paragraphs. • Unpack the appliance and check if there are damages on it. Do not connect the appliance if it is damaged. Report possible damages immediately to the place you bought it. In that case retain packing. • It is advisable to wait at least four hours before connecting the appliance to allow the oil to flow back in the compressor.
Control panel 7 3 Fridge Temperature warmer button 4 Mode button 5 OK button 6 Freezer Temperature colder button 7 Freezer Temperature warmer button 8 Display It is possible to change predefined sound of buttons to a loudly one by pressing together Mode button and Temperature colder button for some seconds. Change is reversible.
Control panel 2. The display switches off. 3. To disconnect the appliance from the power disconnect the mains plug from the power socket. Switching off the fridge To switch off the fridge: 1. Press the Mode button until the corresponding icon appears. The fridge Off indicator and the fridge compartment indicator flash. The fridge temperature indicator shows dashes. 2. Press the OK button to confirm. 3. The fridge Off indicator is shown. Switching on the fridge To switch on the fridge: 1.
Control panel 9 2. Press the Fridge Temperature button to change the Timer set value from 1 to 90 minutes. 3. Press the OK button to confirm. The Minute Minder indicator is shown. The Timer start to flash (min). At the end of the countdown the Minute Minder indicator flashes and an audible alarm sounds: 1. Remove any drinks contained in the freezer compartment. 2. Press OK button to switch off the sound and terminate the function.
Control panel Door open alarm An acoustic alarm will sound if the fridge door is left open for a few minutes. The door open alarm conditions are indicated by: • flashing Alarm indicator • acoustic buzzer When normal conditions are restored (door closed), the alarm will stop.
First use 11 DYNAMICAIR function To switch on the function: 1. Press the Mode button until the corresponding icon appears. The DYNAMICAIR indicator flashes. 2. Press the OK button to confirm. The DYNAMICAIR indicator is shown. To switch off the function: 1. Press the Mode button until the DYNAMICAIR indicator flashes. 2. Press the OK button to confirm. 3. The DYNAMICAIR indicator goes off. If the function is activated automatically the DYNAMICAIR indicator is not shown (refer to "Daily use").
Daily use DAILY USE Storage of frozen food When first starting up or after a period out of use, before putting the products in the compartment let the appliance run at least 2 hours on the higher settings. In the event of accidental defrosting, for example due to a power failure, if the power has been off for longer than the value shown in the technical characteristics chart under "rising time", the defrosted food must be consumed quickly or cooked immediately and then re frozen (after cooling).
Daily use Movable shelves The walls of the refrigerator are equipped with a series of runners so that the shelves can be positioned as desired. Bottle rack Place the bottles (with the opening facing front) in the pre positioned shelf. If the shelf is positioned horizontally, place only closed bottles. This bottle holder shelf can be tilted in order to store previously opened bottles. To obtain this result, pull the shelf up so it can rotate upwards and be placed on the next higher level.
Daily use Positioning the door shelves To permit storage of food packages of various sizes, the door shelves can be placed at different heights. To make these adjustments proceed as follows: gradually pull the shelf in the direction of the arrows until it comes free, then reposition as required. FRESHBOX drawer The drawer is suitable for storing fresh food like fish, meat, seafood, because the temperature is lower here than in the rest of the fridge.
Helpful hints and tips 15 Removal of freezing baskets from the freezer 2 2 1 1 The freezing baskets have a limit stop to prevent their accidental removal or falling out. At the time of its removal from the freezer, pull the basket towards yourself and, upon reaching the end point, remove the basket by tilting its front upwards. At the time of putting it back, slightly lift the front of the basket to insert it into the freezer. Once you are over the end points, push the baskets back in their position.
Care and cleaning Meat (all types) : wrap in polythene bags and place on the glass shelf above the vegetable drawer. For safety, store in this way only one or two days at the most. Cooked foods, cold dishes, etc..: these should be covered and may be placed on any shelf. Fruit and vegetables: these should be thoroughly cleaned and placed in the special drawer(s) provided.
Care and cleaning 17 This appliance contains hydrocarbons in its cooling unit; maintenance and recharging must therefore only be carried out by authorized technicians. Periodic cleaning The equipment has to be cleaned regularly: • clean the inside and accessories with lukewarm water and some neutral soap. • regularly check the door seals and wipe clean to ensure they are clean and free from debris. • rinse and dry thoroughly. Do not pull, move or damage any pipes and/or cables inside the cabinet.
What to do if… Defrosting of the freezer The freezer compartment of this model, on the other hand, is a "no frost" type. This means that there is no buildup of frost when it is in operation, neither on the internal walls nor on the foods. The absence of frost is due to the continuous circulation of cold air inside the compartment, driven by an automatically controlled fan. WHAT TO DO IF… CAUTION! Before troubleshooting, disconnect the power supply.
What to do if… Problem Possible cause 19 Solution Water flows on the ground. The melting water outlet does not flow in the evaporative tray above the compressor. Attach the melting water outlet to the evaporative tray. There is too much frost and ice. Products are not wrapped properly. Wrap the products better. The door is not closed correctly. Refer to "Closing the door". The temperature in the refrigerator is too low. Set a higher temperature. The door is not closed correctly.
Technical data TECHNICAL DATA Dimension Height 2010 mm Width 595 mm Depth 658 mm Rising Time 18 h Voltage 230 240 V Frequency 50 Hz The technical information are situated in the rating plate on the internal left side of the appliance and in the energy label. INSTALLATION WARNING! Read the "Safety Information" carefully for your safety and correct operation of the appliance before installing the appliance.
Installation 21 B A 20 mm The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc. Ensure that air can circulate freely around the back of the cabinet. To ensure best performance, if the appliance is positioned below an overhanging wall unit, the minimum distance between the top of the cabinet and the wall unit must be at least 100 mm . Ideally, however, the appliance should not be positioned below overhanging wall units.
Installation 3 Brown: Live 5 Blue: Neutral As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: 1. Connect the wire coloured green and yellow to the terminal marked either with the letter “E“ or by the earth symbol or coloured green and yellow. 2. Connect the wire coloured blue to the terminal either marked with the letter “N“ or coloured black. 3.
Installation 23 Levelling When placing the appliance ensure that it stands level. This can be achieved by two adjustable feet at the bottom in front. Removing the shelf holders Your appliance is equipped with shelf retainers that make it possible to secure the shelves during transportation. To remove them proceed as follows: 1. Move the shelf holders in the direction of the arrow (A). 2. Raise the shelf from the rear and push it forward until it is freed (B). 3. Remove the retainers (C).
Installation 1. 2. 3. 4. 5. 6. 7. Open the doors. Unscrew the middle hinge (m2). Remove the plastic spacer (m1). Remove the spacer (m6) and move to the other side of the hinge pivot (m5). Remove the doors. Remove the left hand cover pin of the middle hinge (m3,m4) and move to the other side. Fit the pin of the middle hinge (m5) into the left hand hole of the lower door. m1 m5 m3 m2 m6 m4 Remove using a tool the cover (b1).
Environmental concerns 25 10. Install the handle in the opposite side. h4 h5 h6 Re screw the handle bracket on the door (h4). Turn the handle bracket with the handle and screw them to the door (h5) and the fitted handle bracket (h6). 11. Re insert the lower door on the lower hinge pivot (b2). 12. Insert the middle hinge (m2) into the left drill of the lower door. 13. Unscrew the upper hinge pivot (t1) and place it on the opposite side. 14. Fit the upper door on the upper door pivot. 15.
-"- www.aeg.
