EN User Manual Refrigerator S83820KMW3 S83820KMX3 S83820KMB3
www.aeg.com CONTENTS 1. SAFETY INFORMATION.................................................................................................3 2. SAFETY INSTRUCTIONS................................................................................................ 4 3. OPERATION.................................................................................................................... 5 4. DAILY USE.......................................................................................................
ENGLISH 1. 3 SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. 1.
www.aeg.com • • • • Do not use water spray and steam to clean the appliance. Clean the appliance with a moist soft cloth. Only use neutral detergents. Do not use abrasive products, abrasive cleaning pads, solvents or metal objects. Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. 2.
ENGLISH • Do not change the specification of this appliance. • Do not put electrical appliances (e.g. ice cream makers) in the appliance unless they are stated applicable by the manufacturer. • Be careful not to cause damage to the refrigerant circuit. It contains isobutane (R600a), a natural gas with a high level of environmental compatibility. This gas is flammable. • If damage occurs to the refrigerant circuit, make sure that there are no flames and sources of ignition in the room. Ventilate the room.
www.aeg.com 3.2 Display 1 2 1 2 3 4 5 6 7 8 8 7 6 Holiday function ExtraHumidity function Timer Temperature indicator Alarm indicator MinuteMinder function COOLMATIC function ChildLock function 5 4 3 3.3 Switching on 1. Connect the mains plug to the power socket. 2. If the display is off, press ON/OFF. If DEMO appears on the display, the appliance is in demonstration mode. Refer to "What to do if...". The temperature indicators show the set default temperature.
ENGLISH audible alarm sounds. Press OK to switch off the sound and terminate the function. It is possible to deactivate the function at any time during the countdown by repeating the function steps, until the indicator turns off. 3.7 ChildLock function Activate the ChildLock function to lock the buttons from unintentional operation. 1. Press Mode until the corresponding icon appears. The ChildLock indicator flashes. 2. Press OK to confirm. The ChildLock indicator is shown.
www.aeg.com Make sure that the air lever flap is closed to obtain proper function. 1. Gradually pull in the direction of the arrows until it comes free. 4.2 Vegetable Drawer The drawer is suitable for storing fruit and vegetables. Some models have a separator inside the drawer that can be placed in different positions to allow for the subdivision best suited to personal needs. All parts inside the drawer can be removed for cleaning purposes. 4.
ENGLISH 4.6 Cleaning the interior 1. Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and neutral soap so as to remove the typical smell of a brandnew product, then dry thoroughly. 2. Check that the drain hose at the rear of the cabinet discharges into the drip tray. 9 CAUTION! Do not use detergents or abrasive powders, as these will damage the finish. 5. HINTS AND TIPS 5.
www.aeg.com 5.5 Hints for temperature inside the refrigerator A suitable temperature inside the refrigerator is approximately +5° C. If the temperature regulator is set to a too cold temperature, the ambient temperature is high or if the appliance is fully loaded the compressor will run for a longer time. If too cold, change to a higher temperature setting.
ENGLISH compressor stops, during normal use. The defrost water drains out through a trough into a special container at the back of the appliance, over the motor compressor, where it evaporates. It is important to periodically clean the defrost water drain hole in the middle of the refrigerator compartment channel to prevent the water overflowing and dripping onto the food inside. 11 1. Disconnect the appliance from electricity supply. 2. Remove all food. 3. Clean the appliance and all accessories. 4.
www.aeg.com Problem Possible cause Audible or visual alarm is on. The cabinet has been recently switched on or the temperature is still too high. Solution Refer to "Door Open Alarm"or "High Temperature Alarm". The temperature in the ap- Refer to "Door Open Alarm"or pliance is too high. "High Temperature Alarm". The door is left open. Close the door. The temperature in the ap- Contact a qualified electrician pliance is too high. or contact the nearest Authorized Service Centre.
ENGLISH Problem 13 Possible cause Solution Food products prevent that water flows into the water collector. Make sure that food products do not touch the rear plate. Water flows on the floor. The melting water outlet is Attach the melting water outnot connected to the let to the evaporative tray. evaporative tray above the compressor. Temperature cannot be set. The COOLMATIC function Switch off COOLMATIC manis switched on.
www.aeg.com 7.3 Replacing the lamp The appliance is equipped with a longlife LED interior light. Only service is allowed to replace the lighting device. Contact your Authorised Service Centre. 8. INSTALLATION WARNING! Refer to Safety chapters. 8.1 Positioning • behind and above the top cupboard. In this case, the space behind the top cupboard must be at least 50 mm deep.
ENGLISH 8.4 Removing the transport support Your appliance is equipped with transport support to secure the door during transportation. 1. Open the door. 2. Remove the transport support from the door sides. 3. Remove the transport support from the lower hinge (some models). 15 8.6 Levelling When placing the appliance ensure that it stands level. If necessary adjust the feet using the adjustment spanner supplied. Door alignment is dependent on proper levelling.
www.aeg.com 1 2 3 8.8 Door reversibility WARNING! Before carrying out any operations, remove the plug from the power socket. CAUTION! To carry out the following operations, we suggest that this be made with another person that will keep a firm hold on the doors of the appliance during the operations. 1. Remove the ventilation grille. Remove the upper filling and install it on the opposite side of the grille. 2. Lay down the appliance back side down on a wooden support. 3.
ENGLISH 13. Put the cabinet in position. CAUTION! Reposition, level the appliance, wait for at least four hours and then connect it to the power socket. 2 1 Do a final check to make sure that: • All screws are tightened. • The magnetic seal adheres to the cabinet. • The door opens and closes correctly. If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket.
www.aeg.com SSSRRR! HISSS! BLUBB! CLICK! SSSRRR! BRRR! HISSS! CLICK! BRRR! CRACK! BLUBB! 10. TECHNICAL INFORMATION 10.
ENGLISH Frequency Hz The technical information are situated in the rating plate, on the external or 19 50 internal side of the appliance and in the energy label. 11. ENVIRONMENT CONCERNS Recycle the materials with the symbol . Put the packaging in applicable containers to recycle it. Help protect the environment and human health and to recycle waste of electrical and electronic appliances. Do not dispose appliances * marked with the symbol with the household waste.
298377086-B-342014 www.aeg.
