User manual

Problem Possible cause Solution
Sediment in the water. Remove and clean the strainer
in the inlet hose connection.
Water supply obstructed. Check water supply.
Only gas comes out when
dispensing carbonated wa-
ter.
Sediment in the water. Remove and clean the strainer
in the inlet hose connection.
Dispensing is interrupted af-
ter a short time.
The maximum time of two
minutes is exceeded.
Start new dispensing.
The "Water circuit cleaning"
and "Still cold water" indica-
tors are shown.
No water has been dis-
pensed in 10 days.
Dispense water in total 2 mi-
nutes and the icons goes off.
The buzzer sounds. The
"Alarm" icon and "Extra Hu-
midity" icons are flashing.
Failed water supplies. "Press any button to reset the
alarm. Select still cold water
and push the water dispensing
lever and release. The water
pump start and filling the wa-
ter system. After a few minutes
the icons goes off.
Dispensing water more
than 2 minutes.
Release the water dispensing
lever and press any button to
reset the alarm. Start new dis-
pensing.
The water filter indicator
flashes.
The filter has been totally
consumed.
Refer to "Replacing the water
filter".
The water filter indicator
lights constantly.
20% of filter capacity re-
mains.
Buy a new filter.
The temperature in the ap-
pliance is too low/too high.
The temperature regulator
is not set correctly.
Set a higher/lower tempera-
ture.
The door is not closed cor-
rectly.
Refer to "Closing the door".
Food products placed in
the appliance were too
warm.
Allow food products to cool to
room temperature before stor-
ing.
Many food products were
put in at the same time.
Wait some hours and then
check the temperature again.
The door has been
opened often.
Open the door only if necessa-
ry.
The COOLMATIC function
is switched on.
Refer to "COOLMATIC func-
tion".
There is no cold air circula-
tion in the appliance.
Make sure that there is cold air
circulation in the appliance.
ENGLISH 35