Operation Manual

ENGLISH 11
BEFORE FIRST USE
INSTALLING WATER LINE
1.
For models with Automatic Ice
Maker
– The water pressure should be
2.0~12.5 kgf/cm2 or more to run
the Automatic Ice Maker.
– Check your tap water pressure. If a
cup of 180 cc is full within 10 sec-
onds, the pressure is appropriate.
– If the water pressure is not high
enough to run the Automatic Ice
Maker, call the local plumber to get
an additional water pressure pump.
2.
When installing the water tubes, en-
sure they are not close to any hot sur-
faces.
3.
The water filter only “filters” water. It
does not eliminate any bacteria or mi-
crobes.
4.
The filter life depends on the amount
of use. We recommend you replace
the filter at least once every 6 months.
When attaching the filter, place it for
an easy access (to remove and re-
place) .
5.
After installing refrigerator and water
line system, select WATER on your
control panel and press it for 2–3 mi-
nutes to supply water into the water
tank and dispense water.
0
www.aeg.com
DAILY USE
TEMPERATURE CONTROL
When the appliance is plugged in for a
first time, the temperature mode is set to
Middle.
DISPENSER MODEL
Freezer Compartment
For temperature setting push button,
until desired value displays.
For Faster Freezing function hold
but-
ton until super LED turns on. To stop this
function, just push the button again.
Refrigerator Compartment
For temperature setting push button,
until desired value displays.
For Faster Cooling function hold
but-
ton until super LED turns on. To stop this
function, just push the button again.
Temperature indicator convert
function (Fahrenheit-Celsius)
Default setting is Celsius.
Press lock button
to enter
locked mode. Under the locked
mode , press
and WATER but-
ton at the same time for 10 sec-
onds to swap temperature scale.
NON DISPENSER MODEL
Freezer Compartment
For temperature setting push
button until desired temper-
ature displays.
For Faster Freezing function hold
button until super LED turns
on. To stop this function, just push the
button again.
Refrigerator Compartment
For temperature setting push
button until desired temper-
ature displays.
For Faster Cooling function hold
button until super LED turns
on. To stop this function, just push the
button again.
CAUTION!
Food in refrigerator can be frozen
if the ambient temperature of the
refrigerator is below 5° C.
HIGH TEMPERATURE MODE
DISPENSER MODEL
An increase in temperature in freezer or
refrigerator compartment is indicated by:
•
flashing the alarm icon
(buzzer does
not sound)
• electronic system shows the maximum
temperature reached inside the com-
partments
Even though normal operation of
the appliance is restored and in-
ner temperature reaches a normal
range, alarm icon
still blinks
and display indicator shows the
highest temperature reached .
When you press Lock button ,
alarm mode is terminated and
alarm icon
goes off. The dis-
play shows adjusted temperature
value.
NON DISPENSER MODEL
An increase in temperature in freezer or
refrigerator compartment is indicated by:
• flashing of a display of freezer or / and
refrigerator compartment
• electronic system shows the maximum
temperature reached inside the com-
partments
(1*/,6+ 1