EN User Manual Fridge Freezer SCN51810S0
www.aeg.com CONTENTS 1. SAFETY INFORMATION.................................................................................................3 2. SAFETY INSTRUCTIONS................................................................................................ 4 3. OPERATION.................................................................................................................... 6 4. DAILY USE.......................................................................................................
ENGLISH 1. 3 SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. 1.
www.aeg.com • • • • Do not use water spray and steam to clean the appliance. Clean the appliance with a moist soft cloth. Only use neutral detergents. Do not use abrasive products, abrasive cleaning pads, solvents or metal objects. Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance. If the supply cord is damaged, it must be replaced by the manufacturer, its Authorised Service Centre or similarly qualified persons in order to avoid a hazard. 2.
ENGLISH • Do not change the specification of this appliance. • Do not put electrical appliances (e.g. ice cream makers) in the appliance unless they are stated applicable by the manufacturer. • Be careful not to cause damage to the refrigerant circuit. It contains isobutane (R600a), a natural gas with a high level of environmental compatibility. This gas is flammable. • If damage occurs to the refrigerant circuit, make sure that there are no flames and sources of ignition in the room. Ventilate the room.
www.aeg.com 3. OPERATION 3.1 Control panel 1 2 4 1 2 3 4 Temperature indicator LED FROSTMATIC indicator FROSTMATIC button Temperature regulator ON/OFF button 3 3.2 Switching on 1. Insert the plug into the wall socket. 2. Touch the temperature regulator button if all LED are off. 3.
ENGLISH 7 4. DAILY USE WARNING! Refer to Safety chapters. 4.1 Movable shelves The walls of the refrigerator are equipped with a series of supports so that the shelves can be positioned as desired. 4.2 Positioning the door shelves To permit storage of food packages of various sizes, the door shelves can be placed at different heights. To make these adjustments proceed as follows: 1. Gradually pull the shelf in the direction of the arrows until it comes free. 2. Reposition the shelf as required.
www.aeg.com When the freezing process is completed, return to the required temperature (see "FROSTMATIC Function"). In this condition, the refrigerator compartment temperature might drop below 0°C. If this occurs reset the temperature regulator to a warmer setting. 4.4 Storage of frozen food When first starting-up or after a period out of use, before putting the products in the compartment let the appliance run at least 2 hours on the higher settings.
ENGLISH • Meat (all types) : wrap in polythene bags and place on the glass shelf above the vegetable drawer. • For safety, store in this way only one or two days at the most. • Cooked foods, cold dishes, etc..: these should be covered and may be placed on any shelf. • Fruit and vegetables: these should be thoroughly cleaned and placed in the special drawer(s) provided.
www.aeg.com 6.2 Periodic cleaning CAUTION! Do not pull, move or damage any pipes and/or cables inside the cabinet. the refrigerator compartment channel to prevent the water overflowing and dripping onto the food inside. CAUTION! Take care of not to damage the cooling system. CAUTION! When moving the cabinet, lift it by the front edge to avoid scratching the floor. The equipment has to be cleaned regularly: 1. Clean the inside and accessories with lukewarm water and some neutral soap. 2.
ENGLISH 11 7.1 What to do if... Problem Possible cause Solution The appliance does not operate. The appliance is switched off. Switch on the appliance. The mains plug is not con- Connect the mains plug to the nected to the mains socket mains socket correctly. correctly. There is no voltage in the mains socket. Connect a different electrical appliance to the mains socket. Contact a qualified electrician. The appliance is noisy. The appliance is not supported properly.
www.aeg.com Problem Possible cause Solution Water flows on the floor. The melting water outlet is Attach the melting water outnot connected to the let to the evaporative tray. evaporative tray above the compressor. Temperature cannot be set. The FROSTMATIC or COOLMATIC function is switched on. The temperature in the appliance is too low/too high. The temperature regulator Set a higher/lower temperais not set correctly. ture.
ENGLISH Climate class Ambient temperature SN +10°C to + 32°C N +16°C to + 32°C ST +16°C to + 38°C T +16°C to + 43°C Some functional problems might occur for some types of models when operating outside of that range. The correct operation can only be guaranteed within the specified temperature range. If you have any doubts regarding where to install the appliance, please turn to the vendor, to our customer service or to the nearest Authorised Service Centre. 8.
www.aeg.com 8.3 Ventilation requirements The airflow behind the appliance must be sufficient. 5 cm 7. Tighten the lower pin on the opposite side. min. 200 cm2 min. 200 cm2 CAUTION! Refer to the assembly instructions for the installation. 8.4 Door reversibility 1. Loosen and remove the upper pin. 2. Remove the upper door. 3. Remove the spacer. 4. Loosen the middle hinge. 8. Install the lower door. 9. Tighten the middle hinge. 10. Install the spacer. 11. Install the upper door. 12.
ENGLISH 15 x 4 mm x 44 mm 2. Install the appliance in the niche. 3. Push the appliance in the direction of the arrows (1) until the upper gap cover stops against the kitchen furniture. 2 7. Attach the appliance to the niche with 4 screws. I 1 I 4. Push the appliance in the direction of the arrows (2) against the cupboard on the opposite side of the hinge. 5. Adjust the appliance in the niche. Make sure that the distance between the appliance and the cupboard front-edge is 44 mm.
www.aeg.com G H 9. Attach the covers (C, D) to the lugs and the hinge holes. 14. Tighten the screws of the part (G) again. 15. Attach the part (H) to the part (G). 16. Disconnect the parts (Ha), (Hb), (Hc) and (Hd). C D Hb Ha E E Hc B 10. Install the vent grille (B). 11. Attach the hinge covers (E) to the hinge. 12. Connect the appliance laterally to the kitchen furniture sidewall. 13. Loosen the screws of the part (G) and move the part (G) till the furniture sidewall. Hd 17.
ENGLISH 17 23. Place the small square on the guide again and fix it with the screws supplied. 24. Align the kitchen furniture door and the appliance door by adjusting the part (Hb). Ha Hc 19. Open the appliance door and the kitchen furniture door at an angle of 90°. 20. Insert the small square (Hb) into guide (Ha). 21. Put together the appliance door and the furniture door and mark the holes. Hb 25. Press the part (Hd) on the part (Hb). 8 mm Hb Ha Hd Hb 22.
www.aeg.com 9. NOISES There are some sounds during normal running (compressor, refrigerant circulation).
ENGLISH BLUBB! CRACK! BLUBB! 19 CRACK! 10. TECHNICAL INFORMATION 10.1 Technical data Dimensions of the recess Height mm 1780 Width mm 560 Depth mm 550 Rising time Hours 16 Voltage Volts 230 - 240 Frequency Hz 50 The technical information are situated in the rating plate, on the external or internal side of the appliance and in the energy label. 11. ENVIRONMENT CONCERNS Recycle the materials with the symbol . Put the packaging in applicable containers to recycle it.
222370667-A-382014 www.aeg.