SCN71800S0 EN User manual
www.aeg.com CONTENTS 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. SAFETY INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 CONTROL PANEL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 DAILY USE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 HELPFUL HINTS AND TIPS . . . . . . . . . . . . . .
ENGLISH 1. 3 SAFETY INFORMATION In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features.
www.aeg.com 2. • • • • Make sure that the power plug is not squashed or damaged by the back of the appliance. A squashed or damaged power plug may overheat and cause a fire. 3. Make sure that you can come to the mains plug of the appliance. 4. Do not pull the mains cable. 5. If the power plug socket is loose, do not insert the power plug. There is a risk of electric shock or fire. 6. You must not operate the appliance without the lamp cover (if foreseen) of interior lighting. This appliance is heavy.
ENGLISH 5 ant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish. The insulation foam contains flammable gases: the appliance shall be disposed according to the applicable regulations to obtain from your local authorities. Avoid damaging the cooling unit, especially at the rear near the heat exchanger. The materials used on this appliance marked by the are recyclable. symbol 1.
www.aeg.com 4. If "dEMo" appears on the display, the appliance is in demonstration mode. Refer to "WHAT TO DO IF..." paragraph. 5. The temperature indicators show the set default temperature. To select a different set temperature refer to "Temperature regulation". 2.3 Switching off To switch off the appliance do these steps: 1. Press the appliance ON/OFF button for 5 seconds. 2. The display switches off. 3. To disconnect the appliance from the power disconnect the mains plug from the power socket. 2.
ENGLISH To switch on the function: 1. Press the Mode button until the corresponding icon appears. 2. The Child Lock indicator flashes. 3. Press the OK button to confirm. The Child Lock indicator is shown. To switch off the function: 1. Press the Mode button until the Child Lock indicator flashes. 2. Press the OK button to confirm. 3. The Child Lock indicator goes off. 2.
www.aeg.com 1. Press the Mode button until the corresponding icon appears. The FROSTMATIC indicator flashes. 2. Press the OK button to confirm. The FROSTMATIC indicator is shown. This function stops automatically after 52 hours. To switch off the function before its automatic end: 1. Press the Mode button until the FROSTMATIC indicator flashes. 2. Press the OK button to confirm. 3. The FROSTMATIC indicator goes off. The function switches off by selecting a different freezer set temperature. 3.
ENGLISH In the event of accidental defrosting, for example due to a power failure, if the power has been off for longer that the value shown in the technical characteristics chart under "rising time", the defrosted food must be consumed quickly or cooked immediately and then re-frozen (after cooling). 3.4 Thawing Deep-frozen or frozen food, prior to being used, can be thawed in the refrigerator compartment or at room temperature, depending on the time available for this operation.
www.aeg.com 4. HELPFUL HINTS AND TIPS 4.1 Hints for energy saving 4.4 Hints for freezing • Do not open the door frequently or leave it open longer than absolutely necessary. • If the ambient temperature is high and the Temperature Regulator is set to low temperature and the appliance is fully loaded, the compressor may run continuously, causing frost or ice on the evaporator.
ENGLISH 11 • do not exceed the storage period indicated by the food manufacturer. 5. CARE AND CLEANING CAUTION! Unplug the appliance before carrying out any maintenance operation. This appliance contains hydrocarbons in its cooling unit; maintenance and recharging must therefore only be carried out by authorized technicians. 5.1 Periodic cleaning The equipment has to be cleaned regularly: • clean the inside and accessories with lukewarm water and some neutral soap.
www.aeg.com 6. WHAT TO DO IF… WARNING! Before troubleshooting, disconnect the mains plug from the mains socket. Only a qualified electrician or competent person must do the troubleshooting that is not in this manual. Problem Possible cause Solution The appliance is noisy The appliance is not supported properly Check if the appliance stands stable (all the four feet should be on the floor) The appliance does not operate. The lamp does not operate.
ENGLISH Problem Possible cause 13 Solution The compressor This is normal, no error does not start imme- has occurred. diately after pressing the FROSTMATIC or COOLMATIC button, or after changing the temperature. The compressor starts after a period of time. Water flows on the rear plate of the refrigerator. During the automatic defrosting process, frost defrosts on the rear plate. This is correct. Water flows into the refrigerator. The water outlet is clogged. Clean the water outlet.
www.aeg.com Problem Possible cause Solution dEMo appears on the Display. The appliance is in demonstration mode (dEMo). Keep pressed approximately 10 sec. the OK button since a long sound of buzzer is heard and the Display shut off for a short while: appliance start works regularly. 6.1 Replacing the lamp CAUTION! Disconnect the plug from the mains socket. 1. 2. 3. 4. 5. 6.2 Closing the door 1. 2. Press on the rear hook and at the same time slide the cover in the direction of the arrow.
ENGLISH 7.2 Electrical Connection CAUTION! Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. WARNING! This appliance must be earthed. The manufacturer declines any liability should these safety measures not be observed.
www.aeg.com • Loosen and remove the upper pin. • Remove the upper door. • Remove the spacer. • Loosen the middle hinge. • Remove the lower door. S • Loosen and remove the lower pin. On the opposite side: • Tighten the lower pin. • Install the lower door. • Tighten the middle hinge. • Install the spacer. • Install the upper door. • Tighten the upper pin.
ENGLISH 17 7.4 Ventilation requirements 6 cm The airflow behind the appliance must be sufficient. min. 200 cm2 min. 200 cm2 7.5 Installing the appliance Do these steps. CAUTION! Make sure that the mains cable can move freely. If necessary cut the adhesive sealing strip and then apply it to the appliance as shown in figure.
www.aeg.com 2 1 Install the appliance in the niche. Push the appliance in the direction of the arrow (1) until the upper gap cover stops against the kitchen furniture. Push the appliance in the direction of the arrow (2) against the cupboard on the opposite side of the hinge. Adjust the appliance in the niche. Make sure that the distance between the appliance and the cupboard front-edge is 44 mm.
ENGLISH 19 Remove the correct part from the hinge cover (E). Make sure to remove the part DX, in the case of right hinge, SX in opposite case. Attach the covers (C, D) to the lugs and the hinge holes. Install the vent grille (B). Attach the hinge covers (E) to the hinge. C D E E B Connect the appliance laterally to the kitchen furniture sidewall: 1. Fit the bracket (E) and (F), adjust the distance. 2. Fix using the screws (as in figure). 3. Fit the cover (D).
www.aeg.com Disconnect the parts (Ha), (Hb), (Hc) and (Hd). Install the part (Ha) on the inner side of the kitchen furniture. ca. 50 mm 90° 21 mm 90° ca. 50 mm 21 mm Push the part (Hc) on the part (Ha). Ha Hc 8 mm Ha Hb Open the appliance door and the kitchen furniture door at an angle of 90°. Insert the small square (Hb) into guide (Ha). Put together the appliance door and the furniture door and mark the holes.
ENGLISH 21 Remove the brackets and mark a distance of 8 mm from the outer edge of the door where the nail must be fitted (K). 8 mm K Ha Place the small square on the guide again and fix it with the screws supplied. Align the kitchen furniture door and the appliance door by adjusting the part Hb. Hb Press the part (Hd) on the part (Hb). Hb Hd Do a final check to make sure that: • All screws are tightened. 8. NOISES There are some sounds during normal running (compressor, refrigerant circulation).
www.aeg.
ENGLISH 9. TECHNICAL DATA Dimension of the recess Height 1780 mm Width 560 mm Depth 560 mm Rising Time 25 h Voltage 230-240 V Frequency 50 Hz The technical information are situated in the rating plate on the internal left side of the appliance and in the energy label. 10. ENVIRONMENT CONCERNS Recycle the materials with the symbol . Put the packaging in applicable containers to recycle it.
222344537-A-172012 www.aeg.
