SCT51800S0 EN User manual
www.aeg.com CONTENTS 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. SAFETY INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 CONTROL PANEL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 DAILY USE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 HELPFUL HINTS AND TIPS . . . . . . . . . . . . . .
ENGLISH 1. 3 SAFETY INFORMATION In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features.
www.aeg.com 2. • • • • Make sure that the power plug is not squashed or damaged by the back of the appliance. A squashed or damaged power plug may overheat and cause a fire. 3. Make sure that you can come to the mains plug of the appliance. 4. Do not pull the mains cable. 5. If the power plug socket is loose, do not insert the power plug. There is a risk of electric shock or fire. 6. You must not operate the appliance without the lamp cover (if foreseen) of interior lighting. This appliance is heavy.
ENGLISH 5 ant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish. The insulation foam contains flammable gases: the appliance shall be disposed according to the applicable regulations to obtain from your local authorities. Avoid damaging the cooling unit, especially at the rear near the heat exchanger. The materials used on this appliance marked by the are recyclable. symbol 1.
www.aeg.com It is possible to deactivate the function at any time by pressing the FROSTMATIC switch. The FROSTMATIC light will switch off. 2.5 DYNAMICAIR function You can activate the DYNAMICAIR function by pressing the DYNAMICAIR switch. The DYNAMICAIR light will light up. It is possible to deactivate the function at any time by pressing the DYNAMI- CAIR switch. The DYNAMICAIR light will switch off.
ENGLISH cubes. Fill these trays with water, then put them in the freezer compartment. Do not use metallic instruments to remove the trays from the freezer. 7 length of time for which food will keep in the event of a power failure or breakdown. 3.6 Cold accumulators One or more cold accumulators are supplied in the freezer; these increase the 3.7 Movable shelves The walls of the refrigerator are equipped with a series of runners so that the shelves can be positioned as desired. 3.
www.aeg.com 3.10 DYNAMICAIR The refrigerator compartment is equipped with a device that allows for rapid cooling of foods and more uniform temperature in the compartment. This device activates by itself when needed, for example for a quick temperature recovering after door opening or when the ambient temperature is high. Allows you to switch on the device manually when needed (refer to "DYNAMICAIR Function").
ENGLISH • the maximum quantity of food which can be frozen in 24 hrs. is shown on the rating plate; • the freezing process takes 24 hours.
www.aeg.com After cleaning, reconnect the equipment to the mains supply. 5.2 Defrosting of the refrigerator Frost is automatically eliminated from the evaporator of the refrigerator compartment every time the motor compressor stops, during normal use. The defrost water drains out through a trough into a special container at the back of the appliance, over the motor compressor, where it evaporates.
ENGLISH Problem Possible cause The appliance does not operate. The lamp does not operate. The appliance is switched Switch on the appliance. off. 11 Solution The mains plug is not connected to the mains socket correctly. Connect the mains plug to the mains socket correctly. The appliance has no power. There is no voltage in the mains socket. Connect a different electrical appliance to the mains socket. Contact a qualified electrician. The lamp is in stand-by. Close and open the door.
www.aeg.com Problem Possible cause Solution The temperature in the appliance is too high. The temperature regulator is not set correctly. Set a lower temperature. Many products are stored Store less products at the at the same time. same time. The temperature in the refrigerator is too high. There is no cold air circulation in the appliance. Make sure that there is cold air circulation in the appliance. The temperature in the freezer is too high. Products are too near to each other.
ENGLISH 7.2 Electrical Connection CAUTION! Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. WARNING! This appliance must be earthed. The manufacturer declines any liability should these safety measures not be observed.
www.aeg.com 7.3 Door reversibility The door of the appliance opens to the right. If you want to open the door to the left, do these steps before you install the appliance: • Loosen the upper pin and remove the spacer. • Remove the upper pin and the upper door. • Unscrew the pins (B) and spacers (C). C B C • Remove the lower door. • Loosen the lower pin. On the opposite side: • Install the lower pin. • Install the lower door.
ENGLISH 15 7.4 Ventilation requirements 5 cm The airflow behind the appliance must be sufficient. min. 200 cm2 min. 200 cm2 7.5 Installing the appliance Do these steps. CAUTION! Make sure that the mains cable can move freely. If necessary cut the adhesive sealing strip and then apply it to the appliance as shown in figure. x x Drill the hinge cover A, as shown in figure. Apply the covers A and A1 (in the accessories bag) in to the middle hinge.
www.aeg.com 2 Install the appliance in the niche. Push the appliance in the direction of the arrow (1) until the upper gap cover stops against the kitchen furniture. Push the appliance in the direction of the arrow (2) against the cupboard on the opposite side of the hinge. 1 Adjust the appliance in the niche. Make sure that the distance between the appliance and the cupboard front-edge is 44 mm.
ENGLISH 17 Remove the correct part from the hinge cover (E). Make sure to remove the part DX, in the case of right hinge, SX in opposite case. Attach the covers (C, D) to the lugs and the hinge holes. Install the vent grille (B). Attach the hinge covers (E) to the hinge. C D E E B If the appliance must connect laterally to the kitchen furniture door: 1. Slacken the screws in fixing brackets (H). 2. Move the brackets (H). 3. Retighten the screws.
www.aeg.com Disconnect the parts (Ha), (Hb), (Hc) and (Hd). Install the part (Ha) on the inner side of the kitchen furniture. ca. 50 mm 90° 21 mm 90° ca. 50 mm 21 mm Push the part (Hc) on the part (Ha). Ha Hc Open the appliance door and the kitchen furniture door at an angle of 90°. Insert the small square (Hb) into guide (Ha). Put together the appliance door and the furniture door and mark the holes.
ENGLISH 19 Remove the brackets and mark a distance of 8 mm from the outer edge of the door where the nail must be fitted (K). 8 mm K Ha Place the small square on the guide again and fix it with the screws supplied. Align the kitchen furniture door and the appliance door by adjusting the part (Hb). Hb Press the part (Hd) on the part (Hb). Hb Hd Do a final check to make sure that: • All screws are tightened. 8.
www.aeg.
ENGLISH 9. TECHNICAL DATA Dimension of the recess Height 1780 mm Width 560 mm Depth 550 mm Rising Time 21 h Voltage 230-240 V Frequency 50 Hz The technical information are situated in the rating plate on the internal left side of the appliance and in the energy label. 10. ENVIRONMENT CONCERNS Recycle the materials with the symbol . Put the packaging in applicable containers to recycle it.
www.aeg.
ENGLISH 23
222334726-A-172012 www.aeg.
