Operation Manual

18 GB 19 GB
Disposal
Disposal
The packing consists of pollution free materials,
which can dispose of you over the local recy-
cling stations.
Do not throw electrical appliances
into the domestic waste!
In accordance with European guideline
2002 / 96 / EC for electrical and old electronic
devices and conversion to national law, used
electrical appliances must be collected separate-
ly and brought to a environmental fair recycling.
For disposal possibilities for retired electrical
appliances please inform yourself at your
community or city administration.
Illustrations may vary slightly from the product
itself. We reserve the right to administer chang-
es due to technical progress. Decoration not
included.
Operation / Maintenance and care / Service / Warranty / Disposal
Place the other / new wheel in position. Pay
attention that the holes in the rim match
the drillings of the wheel carrier.
First, tighten all wheel nuts by hand.
Place the socket onto the wheel nut and
activate the flip switch clockwise / counter
clockwise rotation
8
by pressing down on the
lower side (symbol h = tighten / clockwise).
After display of the blinking symbol „END“
the wheel nuts are sufficiently tightened.
When using a spare tire, check the air pres-
sure promptly.
When assembling aluminium rims, the impact
wrench should be used with care. Before, set
the torque according to the specifications of
the rim manufacturer.
Check the actual torque using a suitable
torque spanner.
Setting the torque
The electronics of the impact wrench allow a
torque selection of 80 to 340 Nm. The set torque
is shown in the 3-digit display
3
.
When the previously set torque is reached, the
display will show
3
: „END“.
Press the button
5
(G) to increase the
torque. The torque increases by 10 Nm with
every activation.
Press the button
4
(H) to lower the torque.
The torque is reduced by 10 Nm with every
activation.
To set the torque back to 0, press the but-
tons
5
(G) and
4
(H) at the same time
(reset).
Notice: The following displays are possible:
000 -> 080 -> 090 …
The display is increased in steps of 10 and
goes to 340 Nm.
Replacing the fuse on the
12 V-plug
Loosen (and remove) the knurled ring
10
by
turning it counter clockwise.
Remove the defective fuse
11
and replace it
with a new, max. 15 A fuse.
Tighten the knurled ring
10
again by turning
it clockwise.
Maintenance and care
The device is maintenance-free.
WARNING!
Always separate electrical
devices from the power supply, before you carry
out service etc.
Disconnect the device from the 12 V-power
source.
Clean the device with a dry cloth. Do not use
solvents or other aggressive detergents
under any circumstances.
Service
Should you have any questions regarding com-
missioning or operating in spite of studying
these operating instructions, or if a problem
should occur against all expectations, please get
in contact with your specialist supplier.