User manual

8
Türanschlag wechseln
Der Türanschlag kann von rechts (Lieferzustand) nach links gewechselt wer-
den, falls der Aufstellort dies erfordert.
Warnung! Während des Türan-
schlagwechsels darf das Gerät nicht
am Stromnetz angeschlossen sein.
Vorher Netzstecker ziehen.
1. Oberen Scharnierstift abschrau-
ben und Kunstoffteil entfernen.
2. Obere Tür abnehmen.
3. Mittleres Scharnier und Winkeln
abschrauben und auf gegenüber-
liegender Seite wieder anschrau-
ben.
4. Obere Tür wieder einsetzen.
5. Oberen Scharnierstift und Kun-
stoffteil auf gegenüberliegende
Seite wieder anmontieren.
Ihr Kühlgerät braucht Luft
Aus Gründen der Betriebssicherheit
muß eine Mindestbelüftung gewähr-
leistet sein, wie aus der Abb. hervor-
geht:
Achtung:
Die Lüftungs-Öffnungen müssen
immer saubergehalten werden.
Damit die Luft zirkulieren kann, die
Lüftungsöffnungen niemals
abdecken oder verstellen.
50 mm
min.
200 cm
2
200 cm
2
min.
D567
49
The food is too warm.
Interior lighting does not
work.
The appliance is near a heat
source.
Temperature is not properly
adjusted.
Please look in the "Initial Start
Up" section.
Light bulb is defective.
Please look in the "Changing
the Light Bulb" section.
Turn the temperature regula-
tor to a colder setting tempo-
rarily.
Door was open for an exten-
ded period.
Please look in the "Installation
location" section.
A large quantity of warm
food was placed in the
appliance within the last 24
hours.
Open the door only as long as
necessary.
Heavy build up of frost, possi-
bly also on the door seal.
Door seal is not air tight (pos-
sibly after changing over the
hinges).
Carefully warm the leaking
sections of the door seal with
a hair dryer (not hotter than
approx. 50 °C). At the same
time shape the warmed door
seal by hand such that it sits
correctly.
Malfunction Possible Cause Remedy
Appliance does not work.
Appliance is not switched on Switch on the appliance.
Mains plug is not plugged in
or is loose.
Insert mains plug.
Fuse has blown or is defective.
Check fuse, replace if neces-
sary.
Socket is defective.
Mains malfunctions are to be
corrected by an electrician.
Appliance cools too much. Temperature is set too cold.
Turn the temperature regula-
tor to a warmer setting tem-
porarily..