Instructions

6 7
BL18S
........................ 18 V
....................... 2,0 A
................ 350±20 g
................... +5...+40 °C
ENGLISH ENGLISH
WARNING Read all safety warnings, instructions,
illustrations and specifi cations provided with this power
tool. Failure to follow all instructions listed below may result in
electric shock, fi re and/or serious injury.
Save all warnings and instructions for future reference.
SAFETY INSTRUCTIONS
Do not dispose of used battery packs in the household refuse
or by burning them. AEG Distributors off er to retrieve old
batteries to protect our environment.
Do not store the battery pack together with metal objects (short
circuit risk).
Use only System GBS chargers for charging System GBS
battery packs. Do not use battery packs from other systems.
The following battery packs can be
charged with this charger:
Battery Cat.
No.
Cell
Type
DC Volts Capacity Cell No.
L1815G Li-Ion 18 ≤ 1.5 Ah 5
L1820R Li-Ion 18 ≤ 2.0 Ah 5
L1820S Li-Ion 18 ≤ 2.0 Ah 5
L1825R Li-Ion 18 ≤ 2.5 Ah 5
L1830RHD Li-Ion 18 ≤ 3.0 Ah 5
L1830R-X5 Li-Ion 18 ≤ 3.0 Ah 5
L1840R Li-Ion 18 ≤ 4.0 Ah 2x5
L1850R Li-Ion 18 ≤ 5.0 Ah 2x5
L1860R Li-Ion 18 ≤ 6.0 Ah 2x5
L1860R-X5 Li-Ion 18 ≤ 6.0 Ah 2x5
L1860RHD/
L1860B
Li-Ion 18 ≤ 6.0 Ah 2x5
L1890R-X5 Li-Ion 18 ≤ 9.0 Ah 3x5
L1890RHD Li-Ion 18 ≤ 9.0 Ah 3x5
Do not try to charge non-
rechargeable batteries with this
charger.
No metal parts must be allowed to enter the battery section of
the charger (short circuit risk).
Never break open battery packs and chargers and store only in
dry rooms. Keep dry at all times.
Do not touch the tool with conducting objects.
Never charge a damaged battery pack. Replace by a new one.
Before use check machine, cable, and plug for any damages or
material fatigue. Repairs should only be carried out by
authorised Service Agents.
This appliance is not intended to be
used or cleaned by persons with
reduced physical, sensory or mental
capabilities, or lack of experience or
knowledge, unless they have been
given instructions concerning the
safe use of the appliance by a
person legally responsible for their
safety. They should be supervised
whilst using the appliance. Children
shall not use, clean or play with this
appliance, which when not in use
should be secured out of their reach.
Warning! To reduce the risk of fi re, personal injury, and product
damage due to a short circuit, never immerse your tool, battery
pack or charger in fl uid or al-low a fl uid to fl ow inside them.
Corrosive or conductive fl uids, such as seawater, certain
industrial chemicals, and bleach or bleach containing products,
etc., Can cause a short circuit.
SPECIFIED CONDITIONS OF USE
The quick charger can charge AEG System GBS batteries from
18 V.
Do not use this product in any other way as stated for normal
use.
CHARGING TIME
Battery Cat. No. Volts Capacity Charging Time
L1815G 18 V ≤ 1.5 Ah 70 min
L1820R 18 V ≤ 2.0 Ah 90 min
L1820S 18 V ≤ 2.0 Ah 90 min
L1825R 18 V ≤ 2.5 Ah 110 min
L1830RHD 18 V ≤ 3.0 Ah 125 min
L1830R-X5 18 V ≤ 3.0 Ah 125 min
L1840R 18 V ≤ 4.0 Ah 170 min
L1850R 18 V ≤ 5.0 Ah 190 min
L1860R 18 V ≤ 6.0 Ah 210 min
L1860R-X5 18 V ≤ 6.0 Ah 210 min
L1860RHD/
L1860B
18 V ≤ 6.0 Ah 210 min
L1890R-X5 18 V ≤ 9.0 Ah 375 min
L1890RHD 18 V ≤ 9.0 Ah 375 min
MAINS CONNECTION
Connect only to single-phase a.c. current and only to the
system voltage indicated on the rating plate. It is also possible
to connect to sockets without an earthing contact as the design
conforms to safety class II.
TECHNICAL DATA BATTERY CHARGER
Voltage range ...............................................................................
Quick charge current Li-Ion ..........................................................
Weight according EPTA-Procedure 01/2014 ................................
Recommended ambient charging temperature ............................
LIGHT INDICATORS
Continuous green
Standby / Charging is
complete
Flashing green Charging
Continuous orange
Battery or charger is too hot/
cold - charging will begin/
resume when battery or
charger reaches correct
charging temperature
Continuous red
Damaged or faulty battery
pack or charger
Flashing orange Evaluation
BATTERIES
New battery packs reach full capacity after 4 - 5 chargings and
dischargings. Battery packs which have not been used for
some time should be recharged before use.
CHARACTERISTICS
After inserting the battery into the reception of the charger the
battery will automatically be charged (green lamp is fl ashing).
When a hot or cold battery pack is inserted into the charger
(orange lamp is illuminated continuously), charging will begin
automatically once the battery reaches the correct charging
temperature (0°C...50°C).
Charging time varies depending on the battery temperature,
charge needed and the type of battery pack being charged.
As soon as charging is completed, the charger switches over to
”trickle” charge to maintain the full capacity (green control lamp
is illuminated continuously)
If the red lamp is lit, either the battery pack has not been fully
inserted or there is a fault in the battery or the charger. To
ensure your safety, immediately stop using the charger and the
battery pack and have them checked by an AEG Customer
Service Centre.
TRANSPORTING LITHIUM BATTERIES
Lithium-ion batteries are subject to the Dangerous Goods
Legislation requirements.
Transportation of those batteries has to be done in accordance
with local, national and international provisions and regulations.
• The user can transport the batteries by road without further
requirements.
• Commercial transport of Lithium-Ion batteries by third parties
is subject to Dangerous Goods regulations. Transport
preparation and transport are exclusively to be carried out by
appropriately trained persons and the process has to be
accompanied by corresponding experts.
When transporting batteries:
• Ensure that battery contact terminals are protected and
insulated to prevent short circuit.
• Ensure that battery pack is secured against movement within
packaging.
• Do not transport batteries that are cracked or leak.
Check with forwarding company for further advice
MAINTENANCE
If the supply cord of this appliance is
damaged, it must only be replaced
by a repair shop appointed by the
manufacturer, because special
purpose tools are required
Use only AEG accessories and AEG spare parts. Should
components need to be replaced which have not been
described, please contact one of our AEG service agents (see
our list of guarantee/service addresses).
If needed, an exploded view of the tool can be ordered. Please
state the ten-digit No. as well as the machine type printed on
the label and order the drawing at your local service agents or
directly at: Techtronic Industries GmbH, Max-Eyth-Straße 10,
71364 Winnenden, Germany.
SYMBOLS
Please read the instructions carefully before starting
the machine.
Do not burn used battery packs.
Never charge a damaged battery pack.
Replace with a new one.
Do not dispose electric tools, batteries/rechargeable
batteries together with household waste material.
Electric tools and batteries that have reached the
end of their life must be collected separately and
returned to an environmentally compatible recycling
facility.
Check with your local authority or retailer for
recycling advice and collection point.
This tool is only suitable for indoor use. Never
expose tool to rain.
Class II tool.
T2.0A
Time-lag fuse 2.0 A
European Conformity Mark
British Confomity Mark
Ukraine Conformity Mark
EurAsian Conformity Mark