User manual
11
Gerätetür und Möbeltür auf ca.
90° öffnen. Den Winkel (B) in der
Schiene (A) einsetzen. Gerätetür
und Möbeltür zusammenhalten
und die Bohrlöcher anzeichnen
(siehe Abb.). Winkel abnehmen
und die Bohrlöcher mit Ø 2mm
und einem Abstand von 8 mm
von der Türaußenkante bohren.
Den Winkel wieder auf der
Schiene anbringen und mit den
mitgelieferten Schrauben befe-
stigen.
8mm
PR167
A
B
Die Abdeckung (D) in die Schiene
(B) eindrücken, bis sie einrastet.
Für eine allfällig notwendige
Ausrichtung der Möbeltür, den
Spielraum der Langlöcher nut-
zen.
Nach Beendigung der Arbeiten
das einwandfreie Schließen der
Gerätetür überprüfen.
PR168
PR167/1
D
B
34
Prior to Initial Start–Up
• Please clean the appliance interior and all accessories prior to initial start-
up (see section: “Cleaning and Care”).
Starting up and temperature regulation
• Insert the plug into the plug socket. With the refrigerator compartment
door open, the internal lighting is switched on. The temperature selector
knob is located on the RH side of the refrigerator compartment.
Setting „0“ means: Off.
Setting „1“ means: Hightest temperature, (warmest setting).
Setting „6“ (end-stop) means: Lowest temperature, (coldest setting).
However, the exact setting should be chosen keeping in the mind that the
temperature inside the refrigerator depends on:
-the quantity of food stored
-how often the door is opened
The temperatures in the refrigerator compartment and freezer co partment
cannot be independently regulated.
If you want the freeze fresh food rapidly, select setting „6“, ensuring that
the temperature in the refrigerator compartment does not drop blow 0°C.
You should also promptly reset the temperature regulator to setting „3“ or
„4“.
Important!
High ambient temperatures (e.g. on hot summer days) and a cold setting on
the temperature regulator (position"5" to "6") can cause the compressor to
run continuously.
If this happens, turn the temperature regulator back to a warmer setting
(position "3" to "4"). At this setting the compressor will be switched on and
off as usual and automatic defrosting recommenced.