Operation Manual

Problem Possible cause Solution
The product temperature
is too high.
Let the product tempera-
ture decrease to room
temperature before stor-
age.
The room temperature is
too high.
Decrease the room tem-
perature.
Water flows on the
rear plate of the re-
frigerator.
During the automatic de-
frosting process, frost de-
frosts on the rear plate.
This is correct.
Water flows into the
refrigerator.
The water outlet is clog-
ged.
Clean the water outlet.
Products prevent that wa-
ter flows into the water
collector.
Make sure that products
do not touch the rear
plate.
Water flows on the
ground.
The melting water outlet
does not flow in the evap-
orative tray above the
compressor.
Attach the melting water
outlet to the evaporative
tray.
The temperature in
the appliance is too
low.
The temperature regula-
tor is not set correctly.
Set a higher temperature.
The temperature in
the appliance is too
high.
The temperature regula-
tor is not set correctly.
Set a lower temperature.
8.1 Replacing the lamp
CAUTION!
Disconnect the plug from the
mains socket.
1
1
2
1.
At the same time, with the fingers ex-
pand up and down the transparent
cover and unhook it in the direction of
the arrows.
2.
Replace the lamp with one of the same
power and shape, specifically designed
for household appliances. (the maxi-
mum power is shown on the light bulb
cover).
3.
Reassemble the lamp cover.
4.
Connect the plug to the mains socket.
5.
Open the door. Make sure that the
light comes on.
8.2 Closing the door
1.
Clean the door gaskets.
2.
If necessary, adjust the door. Refer
to "Installation".
3.
If necessary, replace the defective
door gaskets. Contact the Service
Center.
ENGLISH 23