User manual
35
3.2.5.4.3 RCCMD Execute/command
This RCCMD signal will cause any RCCMD receiver (e.g. another CS121, RCCMD client or
SITEMANAGER, SITESWITCH4) to execute a command or program.
Figure 30: HTTP - Job Editor: RCCMD execute/command
Any CS121, SITEMANAGER, SITESWITCH can also act as an RCCMD listener; see the
following examples:
3.2.5.4.4 Example of use 1: CS121-adapter as RCCMD-listener
If it is necessary to execute a command with parameters or a user defined script then these
commands must be prepared as an executable batch on the RCCMD client.
The following example toggles the state of AUX output port 2 to high. To ensure that the above
command works with a CS121 as RCCMD client the following four criteria must be met:
• Enable RCCMD Listener and set RCCMD Listener Port in menu “Network & Security”.
• Add IP of UPSMAN sender in the SNMP community of the CS121-RCCMD client (see also
section “SNMP”)
• Target AUX port must be set to "use as Output" (menu AUX, see according section)
• The send RCCMD Command must match the settings of the CS121 RCCMD listener client.
See the UPSMAN User Manual for setting up this job on a computer running UPS
Management Software.
3.2.5.4.5 Example of use 2: CS121-adapter switches an output
CS121 receives an extern RCCMD signal to switch an output at the SS4 (Power switch) which
is connected to the AUX of a CS121.
If you want to send from a CS121, UPSMAN, SITEMANAGER, SITEMONITOR, SITESWITCH
4 or any other RCCMD sender a signal to any other RCCMD client e.g. to switch at its AUX
port an output, please follow the example below.
Note: To let the receiver act as RCCMD listener, same basic settings in menu
“Network & Security” are necessary: Please ensure that the option
“RCCMD Listener” is enabled and the RCCMD Listener port is specified.
(Usually the listener port is 6002)
Figure 31: HTTP – Enable RCCMD Listener
Generally there are 3 commands which can be transmitted from any RCCMD Sender:
Switch Output (AUX): Syntax „
|UPSCMD|20000|x,y“
where “x” is the port number from 1-8 (4 ports for CS121 AUX, SENSORMANAGER and
SITESWITCH and there are 8 ports for the SITEMANAGER)