User manual

Figure 40: HTTP - COM2 & AUX with TEMPMAN

The TEMPMAN and SENSORMANAGER are extensions to the CS121 that connect to COM2

of the adapter. The newer of the two products is the SensorManager. These devices are

simply plugged into the CS121 for setup and the only mandatory change on the adapter to

enable this functioning is to set the COM2 Settings to either TEMPMAN or SENSORMAN. The

configuration is easily achieved via the HTML page of the CS121 web server. Please note the

drop-down menu and entry fields on the page. (see screenshot above) For in-depth

SENSORMANAGER settings see following up chapter.

• RAS-Mode

The selection of the “RAS”-entry in the drop down menu of the COM2 settings enables the

CS121-RASManager function. This function is only operational if a RASMANAGER ist used

(CS121 with inbuilt modem) and a RASMANAGER license key is provided (optional, part of

RASMANAGER). While it is also possible to select this entry in the Telnet menu, it is only

possible to configure the RASMANAGER settings using the HTTP interface of the CS121. See

menu “RAS Configuration” for further settings.

3.2.8.2 AUX and SITESWITCH4 Settings

The AUX connection is an input/output port for connecting external contact devices such as

alarms or for connecting to an SS4AUX SiteSwitch power socket manager. The SS4

SiteSwitch is a standalone device with a built in CS121. The SiteSwitch SS4 AUX is an

inexpensive and practical extension to the CS121 adapters enabling the individual power

switching of up to four power sockets – using the inbuilt AUX port (4 pins) of the CS121. By

entering the corresponding list number, the AUX ports are switched to output or input.

The AUX port can only read signals, if the port is switched to input. If switched to output the

AUX port can send signals to an optocoupler for example. (Refer to the circuit diagrams in the

appendix.) After a reboot, the state of the switches remains in the status previous to the

reboot.

The following describes the configuration of the AUX ports using the HTML interface. All of the

AUX ports 1 – 4 can be manually set to „Output“ so that in the event of an alarm, the CS121

can be preconfigured in the “Events” menu to switch the ports individually. When all ports are