User manual

54
6. CS121-Enhancements, Field of applications
6.1 SiteSwitch4 (SS4) and SiteSwitch4AUX (SS4AUX)
Figure 51: SideSwitch4 and SS4 AUX
SITEWITCH4AUX is a high-performed extension of the CS121-adapter but can also be
operated as stand-alone solution with the possibility to connect to UPS or UPS-similar devices.
The SITESWITCH has 4 power outputs sockets, which can be configurated by the event
settings of the CS121 or any other RCCMD compliant sender like SITEMANAGER,
SITEMONITOR.
Figure 52: CS121-Installation with SideSwitch4
Using the integrated Webserver, the SITESWITCH 4 enables the monitoring and the remote
control of its 4 power outputs. The power sockets can be switched on and off individually. This
can be done either manually via the HTML browser interface or UPSMON or automatically
using the EVENT manager of the CS121 - or any other network CS121 or compatible device.
When executing the action using the EVENT manager of the CS121, the power switching can
be preconfigured to run with delays or to run on a schedule. Both the UPSMON time scheduler
and the HTML time scheduler can be used to configure a power switching time schedule.
This task can also be achieved using the full version of the UNMS UPS Network Management
Software.
Note: (only SS4, not SS4AUX) If you wish to use a UPS with your SS4 then
you must install the appropriate CS121 Firmware on your SS4. The
default Firmware on SS4 (OEMID 27) is for the usage without UPS, as
standalone remote powerswitch. For UPS usage at the SS4 you must
also be sure to set the Exchange COM Ports checkbox and then use the
configuration cable to connect the SS4 with your UPS.