Instruction manual

ENGLISH
32
General safety instructions
To avoid the risk of fi re or an electric shock, you should
not expose the device to rain or moisture. Consequently,
do not use the device in the immediate vicinity of water
- for example near a bath tub, a swimming pool or in a
damp cellar.
Use the device only for the intended purpose.
Only connect the device at a properly installed plug so-
cket. Pay attention that the specifi ed voltage corresponds
to the voltage of the plug socket.
When using external mains supply, pay attention to the
correct polarity and voltage. Always place the batteries in
the correct direction.
Assemble the device in such a way that the available
ventilation openings are not covered.
Never open the housing of the device. Incorrect repairs
can constitute a considerable risk for the user. Should the
device become damaged, in particular the mains supply
cable, do not operate the device any longer, but rather
have it repaired by an expert. Check the mains supply
cable regularly for damage.
For safety reasons a broken or damaged mains lead may
only be replaced by an equivalent lead from the manuf-
acturer, our customer service department or a similary
qualifi ed person.
If the device is not used for a longer period, remove
the plug connector from the plug socket or take out the
batteries.
These symbols may be found on the machine and are
intended to indicate the following:
The lightning symbol should advise the user
of parts in the inside of the device which carry
dangerously high voltage levels.
The symbol with an exclamation mark should
advise the user of important operation or
maintenance instructions in the accompanying
documentation.
Devices bearing this symbol work with a
„class 1 laser“ for tracing the CD. The built-in
safety switches should prevent the user being
exposed to dangerous laser light, which is
invisible to the human eye, when the CD compartment is
opened.
Under no circumstances should these safety switches be
bypassed or manipulated, as this could result in a danger
of exposure to the laser light.
Overview of the Components
1 Set minutes (MINUTE)
2 Hour function key (HOUR)
3 Time setting function key (CLOCK SET)
4 Alarm function key (ALARM SET)
5 Wake-up interval (SNOOZE)
6 Function key for delayed switch-off (SLEEP)
7 Function key (ALARM SLEEP/OFF)
8 ALARM switch (1/2 /1+2)
9 Function selector switch (BUZZER/AUTO/OFF/ON)
10 TUNING control
11 Function selector switch (FM / AM / CD)
12 VOLUME (MIN/MAX)
13
Headphone connection
14 LCD display
15 CD compartment
16 Tab for opening
17 I
 / I SKIP/SEARCH buttons
(forward/reverse search)
18
 CD STOP button
19
 II CD PLAY/PAUSE button
20 RANDOM button
21 PROGRAM/REPEAT button
22 DIMMER button
23 Throw-out antenna
24 Battery compartment
25 AC connection
26 Loudspeakers
Initial Use of the Radio Recorder/
Introduction
• Please read the operating instructions carefully before
using the radio recorder for the fi rst time!
• Select a suitable location for the radio recorder, such
as a dry, fl at, non-slip surface on which it is easy to
operate the machine.
• Ensure that the radio recorder is suffi ciently ventila-
ted!
• Insert the plug into a properly installed 230 V, 50 Hz
power socket. The time 0:00 fl ashes in the display.
Ensure that the voltage is the same as that indicated
on the model identifi cation plate.
Inserting the batteries (not supplied)
If there is a power cut or the mains plug has been remo-
ved from the power socket, the settings will be retained if
the power reserve batteries are inserted.
1. Open the battery compartment (24) on the bottom.
2. Connect a 9 V, E compound battery to the supply
connection. Please ensure the correct polarity.
3. Close the battery compartment again.
4. If the device is not used for a prolonged period of
time, please take the batteries out in order to prevent
leakage of battery acid.
Note: Do not dispose of batteries in the domestic waste.
Please return used batteries to the relevant collection
points or the shop where they were bought.
Never throw batteries into a fi re.
Headphone Socket
Please use headphones with a 3.5 mm jack, which
should be inserted in the
phones socket (13). The
loudspeakers (26) are then switched off.
05-SRC 4306 AEG 32 10.03.2005, 12:13:15 Uhr