Operation Manual

ManualsBrandsAEG ManualsSawstep 570 x

ENGLISH

STEP 570 X, STEP 600 X

Always disconnect the plug from the socket before carrying out any work on the

machine.

1. Push the tension lever as far as it will go,

as shown in the illustration.

2. Fit the saw blade into the groove in the

support roller and push it firmly into the

plunger as far as it will go; the lug of the

saw blade must be in the plunger (see

illustration).

3. Release the tension lever and the saw

blade is gripped automatically.

4. Check that the saw blade fits firmly (wear protective

gloves!); the slot in the plunger must always be at an

angle to the saw blade (see illustration below).

When fixing the saw blade it might be in a slightly

sloping position.

When first cutting it will adjust automatically.

Brief description

III

Modifications: Text, diagrams and data are

correct at the time of printing. In the interest of

continuous improvement of our products,

technical specifications are subject to alteration

without prior notice.

The on-off switch can be fixed in the

”On”- position for continuous operation

by means of the locking button.

The on-off switch is shaped in such a way

that it can be used from the forward or the

rear holding position.

The built-in pendulum stroke improves the cutting performance.

The pendulum stroke of the saw blade means it is only pressed

against the material on the reverse stroke (working stroke) and

lifted off the material on the forward stroke.

Result: better extraction of sawdust, lower friction –> higher cutting

performance.

The pendulum stroke can be adjusted by the pendulum stroke

control and thus adapted to different kinds of material.

The sawdust blower removes sawdust ahead of

the cut – very practical when sawing along a line.

The anti-splintering device almost entirely

prevents the edge of the wood from

splintering.

Integrated suction channel

for connection to a

vacuum-cleaner.

The vibration damper permits quieter running by

means of a counterweight on the plunger.

Integrated tool storage for

spare blade.

The base plate can be tilted to both sides by 45

for bevel cuts.

The stroke-rate (= movements per minute of the saw

blade) can be infinitely varied by means of the

adjustment wheel.

The saw blade can be changed in seconds by

using the tension lever.

Transparent cover for optimum sawdust removal.

Inserting the

saw-blade