User manual

What to do if ...
48
Changing the light bulb
1
Warning!
There is a risk of electric shocks! Before changing the light
bulb, switch off the appliance and unplug it, or pull the fuse or the cir-
cuit breaker.
Light bulb data: 220-240 V, max. 15 W, fitting: E 14
0
To switch off the appliance, turn the temperature regulator to position
"0".
0
Unplug the mains plug.
Interior lighting does not
work.
Light bulb is defective.
Please look in the "Chan-
ging the Light Bulb" sec-
tion.
Heavy build up of frost,
possibly also on the door
seal.
Door seal is not air tight
(possibly after changing
over the hinges).
Carefully warm the lea-
king sections of the door
seal with a hair dryer (not
hotter than approx. 50 °C).
At the same time shape the
warmed door seal by hand
such that it sits correctly.
Unusual noises.
Appliance is not level. Readjust the feet.
The appliance is touching
the wall or other objects.
Move the appliance
slightly.
A component, e.g. a pipe,
on the rear of the
appliance is touching
another part of the
appliance or the wall.
If necessary, carefully
bend the component out
of the way.
The compressor does not
start immediately after
changing the temperature
setting.
This is normal, no error has
occurred.
The compressor starts
after a period of time.
Water on the floor or on
storage shelves.
Water drain hole is blok-
ked.
See the "Cleaning and
Care" section.
Malfunction Possible Cause Remedy