SANTO Z 91200-4 i Refrigerator Operating Instructions PERFEKT IN FORM UND FUNKTION
Dear customer, Before switching on your new appliance please read these operating instructions carefully. They contain important information for safe use, for installation and for care of the appliance. Please keep these operating instructions for future reference. Pass them on to possible new owners of the appliance. These operating instructions are for use with several technically comparable models with varying accessories. Please observe the notes which apply to your model.
Contents Important Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4 Disposal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6 Appliance Packaging Information / Disposal of Old Appliances . . . . . . . . . .6 Remove Transport Packaging . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6 Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Important Safety Instructions These warnings are provided in the interests of your safety. Ensure you fully understand them before installing or using the appliance. Your safety is of paramount importance. If you are unsure about the meaning of these warnings contact the Customer Care Department for assistance. Intended use • The refrigerator is intended for use in the home. It is suitable for the storing of food at low temperature.
Important Safety Instructions Safety of children • Packaging (e.g. wraps, polystyrene) can be dangerous for children. There is a risk of suffocation! Keep packaging material away from children! • Please make old appliances unusable prior to disposal. Pull out the mains plug, cut off the mains cable, break or remove spring or bolt catches, if fitted.
Disposal Appliance Packaging Information All materials are environmentally sound! They can be disposed of or burned at an incinerating plant without danger. About the materials: The plastics can be recycled and are identified as follows: >PE< for polyethylene, e.g. the outer covering and the bags in the interior. >PS< for polystyrene foam, e.g. the pads, which are all free of chlorofluorocarbon.
Installation Installation Location The appliance should be set up in a well ventilated, dry room. Energy use and efficient performance of the appliance is affected by the ambient temperature. The appliance should therefore – not be exposed to direct sunlight; – not be installed next to radiators or other sources of heat; – only be installed at a location whose ambient temperature corresponds to the climate classification, for which the appliance is designed.
Installation Your Refrigerator Needs Air Integratable models (i-appliances) The integrated door of the furniture cabinet largely seals the installation recess. i-appliances must therefore be provided with ventilation by having an opening in the furniture plinth. The warmed air must be able to be exhausted upwards through the air shaft on the furniture back. The ventilation cross-sections should be at least 200 cm2. min. 200 cm2 min. 38 min.
Installation Power Supply ☞ A correctly installed, earthed socket is required for the electrical supply. The supply must have a fuse rating of at least 10 Amps. If the socket is not accessible once the appliance is built in, the electrical installation must include suitable means of isolating the appliance from the mains (e.g. a fused spur).
Installation Electrical Connection Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. 13 AMP WARNING – THIS APPLIANCE MUST BE EARTHED The manufacturer declines any liability should these safety measures not be observed. Before switching on, make sure the electricity supply voltage is the same as that indicated on the appliance rating plate. The rating plate is inside, on the left.
Description of the Appliance View of the Appliance 1 = Control panel 2 = Butter/cheese compartment with flap 3 = Door storage compartment 4 = Bottle shelf 5 = LONGFRESH 0°C compartment with humidity control 6 = Storage shelf (suitable for cans and bottles) 7 = Storage shelves 8 = Air filter 9 = Rating plate 10 = Magnet holder for interior lighting and door alarm 11
Description of the appliance Control Panel 1 2 3 4 5 6 7 8 9 Pilot light (green) ON/OFF switch Temperature setting buttons (for warmer temperatures) Temperature display Temperature setting buttons (for colder temperatures) FROSTMATIC indicator light (yellow) Push button for FROSTMATIC TURBO COOLMATIC indicator light (yellow) Push button for TURBO COOLMATIC Temperature Setting Buttons The temperature is adjusted using the „+“ (WARMER) and „-“ (COLDER) buttons.
Description of the appliance ACTUAL temperature means: The temperature display indicates the temperature that is currently present in the refrigerator. The ACTUAL temperature is indicated by continuously illuminated numbers. Temperature Display The temperature display can indicate several pieces of information. • During normal operation, the temperature currently present in the refrigerator (ACTUAL temperature) is displayed.
Description of the appliance Installation of the charcoal filter On delivery the charcoal filter is placed in a plastic bag to secure the length of life of the charcoal filter. The filter should be placed behind the flap before the appliance is turned on. 1. Pull the cover outward (1). 1 ☞ 2. The charcoal filter is then mounted in the slot found in the back of the cover (2). 3. Close the flap. 2 Important! During operation, always keep the air ventilation flap closed.
Prior to Initial Start–Up ☞ Please clean the appliance interior and all accessories prior to initial start-up (see section: “Cleaning and Care”). Standby time The oil for automatic lubrication contained in the compressor may flow into the refrigeration circuit if the appliance is transported in an inclined position. To allow the oil to flow back into the compressor, wait approximately 1 hour before placing the appliance in operation. Starting Up and Temperature Regulation the plug into the plug socket.
In the LONGFRESH 0°C compartment the temperature is controlled automatically. It stays constantly at about 0°C, no adjustment is necessary. Note: The refrigerator compartment is fitted with a fan. This quickly cools food stuffs and ensures optimal distribution of the temperature between the fridge and the LONGFRESH 0°C compartment. This results in the fan operating at different speeds for different lengths of time. This is quite normal and not a fault with the appliance.
mains power supply, the appliance returns to the same operating state as before the interruption of main power. If the appliance is not going to be used for an extended period: 1. Remove all refrigerated packages. 2. Switch off the appliance by holding down the ON/OFF button until the display goes off (see above). 3. Remove the mains plug or switch off or disconnect from the electricity supply. 4. Clean thoroughly (see section “Cleaning and Care”). 5. Leave the doors open to avoid the build up of odours.
Variable Inner Door The door compartments can be pulled up and removed, and inserted at other positions as needed. Bottle Holder Your model is equipped with a bottle holder in the bottle compartment. This is used to prevent individual bottles from falling over and can be slid sideways. LONGFRESH 0°C Compartment In the LONGFRESH 0°C compartment the temperature is controlled automatically. It stays constantly at about 0°C, no adjustment is necessary.
LONGFRESH 0°C compartment Humidity Control Both drawers can be used according to the desired storage conditions independently of each other with lower or higher humidity. Regulation for each drawer is separate and is controlled using the slide valve at the front of the drawer. • „Dry“: low air humidity - up to 50 % relative humidity This humidity level is reached when both sliders are set into this position and the ventilation openings are wide open.
Correct Storage The refrigerator compartment is fitted with a fan. This quickly cools food stuffs and ensures optimal distribution of the temperature between the fridge and the LONGFRESH 0°C compartment. The following can be conserved in the refrigeration compartment: - beverages, preserves, jars, bottles; - baked goods, prepared foods; - products with short-term expiration; - foods which are not suitable for conservation at the temperature of the LONGFRESH 0°C compartment.
Correct Storage Type of food Beef, venison, small pork cuts, poultry Tomato sauce Fish, shellfish, cooked meat products Cooked seafood Salad, vegetables Carrots, herbs, Brussels sprouts, celery Artichokes, cauliflower, chicory, iceberg lettuce, endive, lamb’s lettuce, lettuce, leeks, radicchio Broccoli, Chinese leaves, kale, cabbage, radishes, Savoy cabbage Peas, kohlrabi Spring onions, asparagus, spinach Fruit (*) Pears, dates (fresh), strawberries, peaches (*) Air humidity adjustment “dry” “dry” “dry” “
Correct Storage Type of food Blackberries, currants Figs (fresh) Blueberries, raspberries Air humidity adjustment “humid” “humid” “humid” Storage time up to 8 days up to 7 days up to 5 days Cakes containing cream and other kinds of pastry products can be stored in the LONGFRESH 0°C compartment for 2 or 3 days.
process. Allowing fruit and vegetables to return to room temperature will improve the texture and flavour. Defrosting The Fridge Defrosts Automatically Defrosting of the fridge compartment is automatic. During defrosting, the air re-circulation fan is off. The water that forms flows into a recipient on the compressor and evaporates. This recipient cannot be removed. Cleaning and Care For hygienic reasons the appliance interior, including interior accessories, should be cleaned regularly.
2. Switch the appliance off and remove the plug from the mains, or switch off or turn out the circuit breaker or fuse. 3. Clean the appliance and the interior accessories with a cloth and lukewarm water with a little bicarbonate of soda added (5ml to 0,5 litres of water). 4. After cleaning wipe with clean water and rub dry. 5. After everything is dry switch the appliance back on. The lowest shelf, dividing the cooler compartment from the LONGFRESH 0°C compartment can be removed for cleaning.
What to do if... Important! Repairs to refrigerators/freezers may only be performed by competent service engineers. Improper repairs can give rise to significant hazards for the user. If your appliance needs repairing, please contact your specialist dealer or your local Service Force Centre. Symptom Appliance does not work. Possible Cause Appliance is not switched on. Mains plug is not plugged in or is loose. Fuse has blown or is defective Socket is defective. Appliance cools too much.
Changing the Light Bulb Warning! There is a risk of electric shocks! Before changing the light bulb, switch off the appliance and unplug it, or disconnect from the mains supply. Light bulb data: 220-240 V, max. 25 W 1. To switch off, press the ON/OFF button until the mains power light goes out. 2. Unplug the mains plug. 3. To change the light bulb, press on the rear hook and at the same time slide the cover in the direction indicated by the arrow. 4. Change the faulty light bulb. 5.
Regulations, Standards, Guidelines This appliance was designed for household use and was manufactured in accordance with the appropriate standards. The necessary measures in accordance with appliance safety legislation regulations (GSG), accident prevention regulations for refrigeration appliances (VBG 20) and the regulations of the German Society of Electrical Engineers (VDE) were observed in the manufacture of this appliance. The refrigerant circuit has been checked for leaks.
AEG Hausgeräte GmbH Postfach 1036 D-90327 Nürnberg http://www.aeg.hausgeraete.