Operation Manual

DELAY START

Allows to delay the start of a drying programme from minimum of 30 min. to maximum

of 20 hours.

1. Select the drying programme and additional options.

2. Press the DELAY START button repeatedly until the desired delay start is shown in the

display, e.g.

if the programme has to start after 12 hours.

3. To activate the delay timer, press the START PAUSE button. Time to start elapses in

the displayed.

Setting child lock

The child lock can be set to prevent a programme being accidentally started or a pro-

gramme in operation being accidentally changed. The child lock function locks all but-

tons and the programme knob. The child lock can be activated or deactivated by holding

down the LONG ANTI-CREASE and BUZZER buttons simultaneously for 5 seconds.

– Before programme is started: Appliance cannot be used

– After programme is started: Programme in operation cannot be changed

The padlock symbol

appears in the display to indicate that the child safety device is

activated.

The child safety device is not deactivated once the programme comes to an end.

If you want to set a new programme, you must first deactivate the child safety device.

Starting the programme

Press the START PAUSE button (6). The programme is started.

The programme progress is shown in LCD by appropriate set of icons. From left to the

right, from iron dry

to anti-crease icon depends on the drying cycle chosen. E. g.

in case of cupboard dry programme the following status icons are visible:

. Current cycle progress is marked by flashing dash under status icon. When appropri-

ate part of drying cycle is accomplished dash becomes steady and appears flashing under

next status icon.

Changing programme

To change a programme which has been selected by mistake once the programme has

started, first turn the programme selector to OFF and then reset the programme.

The programme can no longer be changed directly once the programme has started. If

nevertheless there is an attempt to change the programme on the programme knob, the

programme progress display and the maintenance indicators flash. If an option (exclud-

ing the buzzer ) is set, Err appears in the multidisplay. The drying programme is not how-

ever affected by this (laundry protection).

Programme complete / Laundry unloading

Once the drying cycle is complete, display shows a blinking , under anti-crease icon

appears dash. If the buzzer option has been set, an acoustic signal sounds intermittently

for about one minute.

Daily use