Operation Manual

11. Push against the large mesh filter until

it locks into the interlock.

If the fine strainer is not fitted, the large

mesh filter will not snap into place and the

loading door cannot be closed.

Cleaning the door seal

Clean the door seal with a moist cloth immediately after the drying cycle is completed.

Emptying the water reservoir

Empty the water reservoir after each drying cycle.

If the water reservoir is full, an active programme will break off automatically and the

empty container

symbol on the display will light up. To continue the programme, the

water reservoir must first be empty.

WARNING!

Risk of poisoning. The water from the water reservoir is not applicable to drink or to pre-

pare meals.

Pull out the water reservoir 1 and pull

up the water reservoir drainage pipe as

far as it will go 2 .

2. Pour condensed water out into a basin

or similar receptacle.

3. Slide outlet connections in and refit wa-

ter reservoir.

If the programme has been interrupted

as a result of the water reservoir being

full: Push the START PAUSE button to

continue the drying cycle.

The water from the water reservoir can be

used as distilled water, e.g. for steam iron-

ing. But first filter the water (e.g. with a coffee filter) to remove residue and small pieces

of the fluff.

Care and cleaning