Operation Manual

Cleaning heat exchanger filters

If the indicator clean base filters lights up, the heat exchanger fluff filters in the base

of the appliance must be cleaned, i.e. after each 5 drying cycles. Both filters are located

in the appliance base.

Water can collect in the filter housing therefore it is normal for the heat exchanger fluff

filters to become wet.

• Do not operate the tumble dryer without the fluff filters.

• Clogged filters cause higher energy consumption (drying cycle elongation) and tumble

dryer damage.

• A dirty heat pump can only be cleaned up with a costly process.

1. Open loading door

2. Open door in plinth: To do this, push the

release button on the bottom of the

door aperture and open the door in the

plinth to the left.

3. Pull filter housing out of the base by the

handle.

4. To clean the fluff filter: Remove filter

from filter housing push the pressure

points on the sides and pull the filter

frame up and out of the housing. Re-

move fluff from the fluff filter with a

moist hand.

Care and cleaning