Operation Manual

Particularly high room temperature -

no machine fault.

Lower the room temperature if possible.

1) In case of error message on the LCD (e.g.

E51

- only dryers with the LCD): Switch the dryer off and on. Set

programme. Press the START PAUSE button. Does not work? - inform local service and quote the error code.

2) follow program recommendation - see Programme overview chapter

3) see Care and cleaning chapter

4) see Machine settings chapter

5) only dryers with the LCD

6) Note: After around 5 hours the drying cycle ends automatically (see Drying cycle complete section).

Changing the bulb for interior lighting

Only use a special bulb which is designed specially for dryers. The special bulb can be

obtained from your local service centre.

When the appliance is switched on, the interior lighting switches itself off after 4 mi-

nutes when the door is open.

WARNING!

Do not use standard bulbs! These develop too much heat and may damage the appliance!

Before replacing the bulb, disconnect the mains plug; with a permanent connection:

fully unscrew or deactivate the fuse.

1. Unscrew cover above the bulb (this can be found directly behind the loading aper-

ture, at the top; refer to "Description of machine" section.)

2. Replace defective bulb.

3. Screw cover back down.

Check the correct positioning of o-ring gasket before screwing back the door light cover.

Do not operate the dryer when missing o-ring gasket on door light cover.

WARNING!

For safety reasons, the cover must be screwed down tightly. If this is not done, the dryer

must not be operated.

MACHINE SETTINGS

Setting Implementation

Buzzer permanent

on/off

1. Turn the programme selector to any programme.

2. Press simultaneously the DRYNESS and SPIN SPEED buttons and

hold down for approx. 5 seconds.

The buzzer is by default always off. You can use the buzzer option

to activate or deactivate sound but the machine does not memorise

your selection.

Machine settings