Operation Manual

Setting Implementation
Water hardness
1)
1. Turn the programme selector to any programme.
2. Press simultaneously the DRYNESS and TIME buttons and hold
down for approx. 5 seconds. The current setting is on the display:
–
low conductivity <300 μS/cm
–
medium conductivity 300-600 μS/cm
–
high conductivity >600 μS/cm
3. Press the START PAUSE button sequentially until you set desired level.
4. To memorise setting press simultaneously the DRYNESS and TIME
buttons or turn knob to OFF position
Emptying water res-
ervoir
- warning
off (Only when drain
kit is used)
2)
1. Turn the programme selector to any programme.
2. Press simultaneously the SPIN SPEED and TIME buttons and hold
down for approx. 5 seconds.
The current setting is on the display:
–
warning
icon and - warning message is off
–
warning
icon and - warning message is switched on
1) Water contains, a variable quantity of limestone and mineral salts of which quantities vary according to
geographical locations thus varying its conductivity values. Relevant variations of the conductivity of the
water compared to those prefixed by the factory could slightly influence the residual humidity of the
laundry at the end of the cycle. Your dryer allows you to regulate the sensitivity of the drying sensor based
on conductivity values of the water.
2) By default the warning LED is always on at the end of the drying cycle or during the cycle if the water
reservoir is full. When using an external drain for the condensed water warning can be off.
TECHNICAL SPECIFICATIONS
Height x width x depth 85 x 60 x 58 cm
Drum volume 108 l
Depth with loading door open 109 cm
Height can be adjusted by 1.5 cm
Weight when empty approx. 56 kg
Loading volume (depends on programme)
1)
max. 7 kg
Voltage 230-240 V
Required fuse 13 A
Total power 1050 W
Energy efficiency class
A
Energy consumption (7 kg of cotton, pre-
drained at 1000 rpm)
2)
1.9 kWh
Average annual energy consumption 126.2 kWh
24
Technical specifications