EN User Manual Tumble Dryer LAVATHERM 65170AV
www.aeg.com CONTENTS 1. SAFETY INFORMATION.................................................................................................3 2. SAFETY INSTRUCTIONS................................................................................................ 5 3. ACCESSORIES.................................................................................................................6 4. PRODUCT DESCRIPTION..............................................................................................
ENGLISH 1. 3 SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. 1.1 Children and vulnerable people safety WARNING! Risk of suffocation, injury or permanent disability.
www.aeg.com • • • • • • • • • • • • • supplied with the accessory. Read it carefully before installation (Refer to the Installation leaflet). The appliance can be installed as freestanding or below the kitchen counter with correct space (Refer to the Installation leaflet). Do not install the appliance behind a lockable door, a sliding door or a door with a hinge on the opposite side, where the appliance door can not be fully opened.
ENGLISH • • • • • • 5 Items such as foam rubber (latex foam), shower caps, waterproof textiles, rubber backed articles and clothes or pillows fitted with foam rubber pads should not be dried in the tumble dryer. Fabric softeners, or similar products, should be used as specified by the fabric softener instructions. Remove all objects from pockets such as lighters and matches.
www.aeg.com 2.3 Use WARNING! Risk of injury, electrical shock, fire, burns or damage to the appliance. • Use this appliance in a household only. • Do not dry the damaged items which contain padding or fillings. • Only dry fabrics which are applicable to dry in the tumble dryer. Follow the instructions on the fabric label. • If you have washed your laundry with a stain remover start an extra rinse cycle before you start the dryer. • Do not drink or prepare food with the condensed water/distilled water.
ENGLISH 7 Available from your authorized dealer. To put the appliance higher at the level which helps to easy load and remove the laundry. collects lint and condensation, thus avoiding dirt and damage due to moisture in the room where the tumble dryer is placed. The drawer can be use for laundry storage e.g. : towels, cleaning products and more. Read carefully the instructions supplied with the accessory. Read carefully the instructions supplied with the kit. 3.
www.aeg.com 5. CONTROL PANEL 1 2 9 8 1 Programme knob and OFF switch 2 Push button Delay 3 Indication lamp: clean the filter 4 Push button Start/Pause 5 Function status LED 7 6 7 8 9 6 5 4 3 Push button Buzzer Push button Anti-crease Push button Sensitive Push button Delicate 6. PROGRAMME TABLE Programmes Type of load Load (max.)1) / Fabric mark Cotton Extra Dry Drying level: extra dry. 7kg/ Strong Dry Drying level: strong dry.
ENGLISH Programmes Type of load 9 Load (max.)1) / Fabric mark Time 30’ Time programme to dry individual items of laundry. 1kg/ Refresh Refreshing a textiles that were in storage. 1kg Bed Linen To dry bed linen such as: single and double 2kg/ sheet, pillowcase, bedspread. Jeans Leisure clothing such as jeans, sweat-shirts of different material thicknesses (e.g. at the neck, cuffs and seams). 7kg/ Sports Sportswear, thin and light fabrics, microfiber, polyester, which are not ironed.
www.aeg.com The buzzer function is by default always on. You can use this function to activate or deactivate the sound. You can activate the Buzzer option with all programmes. 7.
ENGLISH 8.1 Adjustment of the remaining laundry moisture degree To change the default degree of the remaining moisture of the laundry: 1. Use the programme knob to set any programme. 2. Wait approximately 8 seconds. 3. Press and hold buttons (A) and (D) at the same time. One of the these indicators comes on: • End - the maximum dry laundry • Cooling - the more dry laundry 11 • End and Cooling the standard dry laundry 4.
www.aeg.com 10.5 Stand-by function When the crease guard phase is completed: • Start/Pause indicator goes off. 1. 2. 3. 4. Turn the Programme knob to Open the appliance door. Remove the laundry. Close the appliance door. OFF Always clean the filter when a programme is completed. To decrease the energy consumption, this function automatically deactivates the appliance: • After 5 minutes if you do not start the programme. • After 5 minutes from the end of the programme. 11. HINTS AND TIPS 11.
ENGLISH 13 1. Open the door. 5. If necessary clean the filter with warm water using a brush. 2. Pull the filter. 6. Close the filter. 7. Remove fluff from the filter socket. For this a vacuum cleaner can be used. 8. Put the filter inside the filter socket . 12.2 Cleaning the drum WARNING! Disconnect the appliance before you clean it. 3. Open the filter. Use a standard neutral soap detergent to clean the inner surface of the drum and drum ribs. Dry the cleaned surfaces with a soft cloth.
www.aeg.com 13. TROUBLESHOOTING Problem Possible solution You cannot activate the appliance. Make sure that the mains plug is connected to the mains socket. Check fuse in fuse box (domestic installation). The programme does not start. Press Start/Pause. Make sure that the appliance door is closed. The appliance door does not close. Make sure that the installation of the filter is correct. Make sure that the laundry does not catch between the appliance door and the rubber seal.
ENGLISH 15 14. TECHNICAL DATA Height x Width x Depth 850 x 600 x 580 mm (maximal 640 mm) Max. depth with the appliance door open 1090 mm Max.
www.aeg.com Programme Iron Dry Spun at / residual humidity Drying time Energy consumption 1400 rpm / 50% 85 min. 2,55 kWh 1000 rpm / 60% 97 min. 3,20 kWh 1200 rpm / 40% 44 min. 1,20 kWh 800 rpm / 50% 49 min. 1,47 kWh Synthetic 3 kg Cupboard Dry 15. INSTALLATION 15.1 Unpacking CAUTION! Before use all parts of the transport packaging must be removed. 1. Open loading door. 15.2 Vent hose 2. Pull off adhesive strips from inside machine on top of drum.
ENGLISH 17 B Note that to prevent condensation problems, it is essential that the dryer be installed with the flexible hose to transmit its “exhaust” at least beyond the kitchen units; preferable outside the kitchen. In order to prevent the appliance from overheating, it is important that the steam exhaust is unobstructed. Thus, if a permanent hose installed to an external wall or ceiling, it must be ensured an exhaust capacity of minimum 150 m3/h.
www.aeg.com 15.3 Load door reversal WARNING! Before changing the door stop, disconnect the mains plug. Note regarding contact protection: The appliance is only secure for operations again once all plastic parts have been put. 1. Open load door. 2. Unscrew hinge A from the front of the appliance and remove the load door. 3. Remove cover plates B. To do this, put a thin screwdriver into the slots as shown in the illustration, push down lightly and remove the cover plates. A B C B A 4.
ENGLISH E D F F E D 8. Unscrew door lock E, push down lightly and remove from the front of the appliance. 9. Push snap-in button F in and down, push cover down lightly and remove from front of the appliance. 19 10. Change door lock E above to the opposite side, screw down the door interlock. 11. On the other side, put cover F and let snap-in button to lock into position. 12. Put load door and hinges into recesses on the front of the appliance and screw down. 16.
136915232-A-372014 www.aeg.
