User manual

A
A
2. Screw on the ring nut to the hose
and push it into position.
A
3. The not used vents must be sealed
with supplied covers.
15.3 Load door reversal
WARNING!
Before changing the door
stop, disconnect the mains
plug.
Note regarding contact
protection: The appliance is
only secure for operations
again once all plastic parts
have been put.
1. Open load door.
2. Unscrew hinge A from the front of
the appliance and remove the load
door.
3. Remove cover plates B. To do this,
put a thin screwdriver into the slots
as shown in the illustration, push
down lightly and remove the cover
plates.
A
A
B
C
B
4. Use an applicable tool and apply
pressure to unlock part C, remove
and turn it through 180°, then put on
the other side. There is a small spring
below locking block C. To put all
parts together correctly, look at the
illustrations:
ENGLISH
19