User manual

• Do not use fabric softener to wash
and then dry. In the tumble dryer
laundry becomes soft automatically.
• Use the condensate as distilled water,
e.g. for steam ironing. If it is necessary
clean the condensate before (e.g.
with a coffee filter) to remove possible
small pieces of fluff.
• Always keep the airflow slots on the
bottom of the appliance clear.
• Make sure that is good airflow in the
appliance installation position.
10.2 Adjustment of the
remaining laundry moisture
degree
To change the default degree of the
remaining moisture of the laundry:
1. Turn on the appliance.
2. Wait approximately 8 seconds.
3. Select 1 of available programmes.
4. Push at the same time and hold
down the Dry Plus and Anti-
crease buttons.
One of the symbols goes into the view
on the display:
- the maximum dry laundry
- the more dry laundry
- the standard dry laundry
5. Push the
Start/Pause button
again and again until you set
necessary degree.
6. To memorise the setting, push at the
same time the Dry Plus and
Anti-crease buttons for
approximately 2 seconds.
10.3 Deactivating the Water
container indicator
1. Turn on the appliance.
2. Wait approximately 8 seconds.
3. Select 1 of available programmes.
4. Push at the same time and hold
down the Dry Plus and
Buzzer buttons.
One of 2 configurations is possible:
•
the Water container indicator:
is on and the symbol
goes into the view - the water
container indicator is permanently
on
•
the Water container indicator:
is off and the symbol
goes into the view - the water
container indicator is permanently
off
11. CARE AND CLEANING
11.1 Cleaning the filter
At the end of each cycle the indicator
Filter is on and you must clean the filter.
ENGLISH 17