User manual

–
low conductivity <300 μS/
cm
–
moderate conductivity
300-600 μS/cm
–
high conductivity >600
μS/cm
3.
Push the button repeatadly until the
required conductivity is shown.
4.
To memorise this setting push the
same two buttons as specified in
point 2.
9.4 Water container full —
indication
By default the indication is always on.
It comes into the view at the end of the
cycle or when the water container is full.
When you use an external equipment to
drain the container, the indication can
be off.
To activate or deactivate the indication:
1.
Turn the programme dial to availa-
ble programme.
2.
Push the two buttons shown below
at the same time until you see the
correct setting:
–
the indication
is off and the in-
dicator
comes into the
view — the indication
is perm-
antly off
–
the indication
is on and the in-
dicator
comes into the
view — the indication
is activa-
ted
10. CARE AND CLEANING
10.1 Cleaning the filter
At the end of each cycle the indicator
(clean the filter) is on to tell you that the
filter must be cleaned.
The filter collects the fluff. The
fluff occurs while the clothes are
dried in the tumble dryer.
To clean the filter:
1.
Open the door.
14
www.aeg.com