User manual

INSTALLATION
APPLIANCE POSITIONING
• The tumble dryer must be installed in
a clean position, where dirt does not
collect.
• Air must flow freely around the appli-
ance. Make sure that the front airflow
slots in the bottom of the appliance
are not blocked .
• To keep vibration and noise at the
minimum, when the tumble dryer op-
erates, it must be put on a stable and
flat surface.
• When the appliance is put in its per-
manent position, check if is fully level
with the aid of a spirit level. If it is
not, adjust the feet until it is.
• Do not remove the feet. Do not de-
crease the floor clearance through
thick carpets, bar of wood or equiva-
lent. This can increase the heat which
can cause interference with the oper-
ation of the appliance.
• The temperature of the hot
air which occurs in the tumble
dryer can increase to 60 °C.
The appliance must not be in-
stalled on the floor which is
not resistant to high tempera-
tures.
• When the tumble dryer oper-
ates, the room temperature
must not be lower than +5 °C
and higher than +35 °C. This
can cause unwanted effect on
the performance of the appli-
ance.
• If it is necessary to move the
appliance, it must be moved
vertically.
• The appliance must not be in-
stalled behind a lockable
door, a sliding door, a door
with a hinge on the opposite
side to that of the appliance
in such a way that a full open-
ing of the tumble dryer is re-
stricted.
UNPACKING
CAUTION!
Before use all parts of the transport
packaging must be removed.
To remove the polystyrene blockages:
1. Open the load door.
2. Pull 2 plastic hoses with the poly-
styrene blockages out from the
drum.
x2
It is possible to adjust the height of the
tumble dryer. To do that adjust the feet
(see picture).
15mm
ENGLISH 61