User manual

–
low conductivity <300 μS/
cm
–
moderate conductivity
300-600 μS/cm
–
high conductivity >600
μS/cm
3.
Push the button again and again un-
til you set necessary level (see the il-
lustration).
4.
To memorise the setting push at the
same time 2 buttons as are specified
in the point 2.
8.3 Water container full —
indication
By default the indication is always on.
It comes into the view at the end of the
cycle or when the water container is full.
When you use an external equipment to
drain the container, the indication can
be off.
To activate or deactivate the indication:
1.
Turn the programme dial to availa-
ble programme.
2.
Push at the same time 2 buttons (see
the illustration) and hold down until
you see the correct setting:
–
the indication
is off and the in-
dicator
comes into the
view — the indication
is per-
manently off
–
the indication
is on and the in-
dicator
comes into the
view — the indication
is activa-
ted
9. CARE AND CLEANING
9.1 Cleaning the primary filter
At the end of each cycle the indicator
(clean the primary filter) is on to tell you
that the primary filter must be cleaned.
The filter collects the fluff. The
fluff occurs while the cloths are
dried in the tumble dryer.
14
www.aeg.com