User manual

• Do not use fabric softener to wash
and then dry. In the tumble dryer
laundry becomes soft automatically.
• Use the condensate as distilled water,
e.g. for steam ironing. If it is necessary
clean the condensate before (e.g.
with a coffee filter) to remove possible
small pieces of fluff.
• Always keep the airflow slots on the
bottom of the appliance clear.
• Make sure that is good airflow in the
appliance installation position.
10.2 Adjustment of the
remaining laundry moisture
degree
To change the default degree of the
remaining moisture of the laundry:
1. Turn on the appliance.
2. Wait approximately 8 seconds.
3. Select 1 of available programmes.
4. Push at the same time and hold
down the Dry Plus (Drogen Plus)
and Spun at RPM (T/Min) buttons.
One of the symbols goes into the view
on the display:
- the maximum dry laundry
- the more dry laundry
- the standard dry laundry
5. Push the Start/Pause (/Pauze)
button again and again until you set
necessary degree.
6. To memorise the setting, push at the
same time the Dry Plus (Drogen
Plus) and Spun at RPM (T/Min)
buttons for approximately 2 seconds.
10.3 Deactivating the Water
container (Reservoir) indicator
1. Turn on the appliance.
2. Wait approximately 8 seconds.
3. Select 1 of available programmes.
4. Push at the same time and hold
down the Dry Plus (Drogen Plus)
and Buzzer (Zoemer) buttons.
One of 2 configurations is possible:
• the Water container (Reservoir)
indicator: is on and the symbol
goes into the view - the
water container indicator is
permanently on
• the Water container (Reservoir)
indicator: is off and the
symbol goes into the
view - the water container
indicator is permanently off
11.
CARE AND CLEANING
11.1 Cleaning the filter
At the end of each cycle the symbol
Filter is on the display and you must
clean the filter.
The filter collects the fluff.
The fluff occurs while the
cloths are dried in the
tumble dryer.
1. Open the door. Pull the filter.
www.aeg.com18