User manual

8 www.aeg.com
avoid hazard.
• Always place the appliance on a at, level surface.
• Always disconnect the appliance from the supply if it is left unattended and
before assembling, disassembling or cleaning.
• Never touch the blades or inserts with your hand or any tools while the
appliance is plugged in.
• The blades and inserts are very sharp! Danger of injury!
•
Do not immerse the appliance in water or any other liquid.
• Do not exceed the maximum lling volume as indicated on the appliances.
• Never process boiling liquids (max 90 °C).
• Do not use this appliance to stir paint. Danger, could result in an explosion!
• Never operate appliance without lid.
• Do not let the power cord touch hot surfaces or hang over edge of table or
counter.
• Never use accessories or parts made by other manufactures not
recommended or sold; may cause a risk of injury to persons.
• Do not grind hard or dry substances in the jug.
• Keep hands and utensils out of the blender during operation to reduce the
risk of severe injury to persons or damage to the blender.
• Ensure that the blender is switched o before removing it from the stand.
• Do not attempt to remove the blade assembly.
• Care shall be taken when handling the sharp cutting blades, emptying the
bowl and during cleaning.
• Be careful if hot liquid is poured into the appliance as it can be ejected out
of the appliance due to a sudden steaming.
• Switch o the appliance and disconnect from supply before approaching
parts that move in use.
• If the product is left on without using any speed or programs, it will
automatically turn o after 5 minutes.
• This appliance is intended for domestic use only. The manufacturer cannot
accept any liability for possible damage caused by improper or incorrect
use.
• CAUTION: In order to avoid a hazard due to inadvertent resetting of the
thermal cut-out, this appliance must not be supplied through an external
switching device, such as a timer, or connected to a circuit that is regularly
switched on and o by the utility.
• DO NOT OPERATE WITHOUT THE COVER IN PLACE.