User manual

Problem
1)
Possible cause Remedy
Abnormally
elapsing
time on the
display.
The time to end is calculated
on the basis of the volume and
dampness of the laundry.
The automatic procedure —
this is not the appliance mal-
function.
Programme
inactive.
The water container is full.
Drain the water container
3)
,
push the Start/Pause button.
Drying cycle
too short.
Too small laundry volume.
Do the selection of time pro-
gramme. The time value must
be related to the load. To dry
one item or small quantities of
the laundry we recommend to
use short times.
The laundry is too dry.
Do the selection of time pro-
gramme or higher drying level
(e.g. Extra Dry )
Drying cycle
too long
6)
The filter is clogged. Clean the filter.
Too high volume of the load.
Obey the maximum load vol-
ume.
The laundry not spun sufficient-
ly.
Spin correctly the laundry.
Very high room temperature -
this is not the appliance mal-
function.
If possible, lower the room
temperature.
1)
If there is an error message on the display (e.g. E51): Turn the tumble dryer off and on.
Make a selection of the new programme. Push the Start/Pause button. Does not
operate? - contact the service centre and give the error code.
2)
follow the programme description — see PROGRAMMES chapter
3)
see CARE AND CLEANING chapter
4)
see section WATER HARDNESS in HINTS AND TIPS chapter
5)
Only the tumble dryers with drum light.
6)
Note: After maximum 5 hours the drying cycle ends automatically (see Drying cycle
complete section).
11. TECHNICAL INFORMATION
height x width x depth 850 x 600 x 600 mm (maximal 640 mm)
drum volume 118 l
maximum depth with the load door
opened
1090 mm
maximum width with the load door
opened
950 mm
48
www.aeg.com