Manual

How to deal with problems...

. the machine does not start:

I Check that the appliance is plugged in.

i Check that a programme has been selected.

I Check that the START/PAUSE button has been pressed.

I Check that the porthole door is firmly shut.

I Check that the fuse has not blown.

. the door will not open:

Check whether a programme is in progress.

Check whether a programme without finai spin has been

seiected.

Check whether the water levei is higher than the bottom of the door.

. the machine does not fill:

Check that the taps are on.

Check whether the filters in the inlet hoses are blocked.

If the machine takes longer than usual to fill with water, check

whether the filters in the inlet hoses are blocked.

To do this, shut the water taps. Unscrew the hoses from fhe

taps and remove the filters. Clean them with an old toothbrush

then refit them.

Tighten up the inlet hoses.

Problems you

can solve

yourself

. spinning starts slowly:

The electronic unbalance detection device has tripped

because the laundry is not evenly distributed in the drum.

When rotation of the drum is reversed the laundry re-distrib-

utes itself. This may happen several times before the unbal

ance disappears and the spin resumes normally.

. the machine vibrates or is noisy:

i With very small loads (for example just one bathrobe) the ma

chine may start to vibrate. This does not however affect per

formance.

i Check that the support feet are correctly adjusted. Refer to

the installation instructions.

I Check that all the transit bolts and packing have been re

moved. Refer fo the installation instructions.