User manual

- 48 -
TV and Operating Buttons
FRONT and REAR VIEW Control Buttons VIEW Control Buttons
Up direction1.
Down direction2.
Programme/Volume / AV / 3.
Standby-On selection switch
Note: You can move the switch,
upward or downward to change
the volume. If you want to change
channels, press the middle of the
switch once (Position 3) and then
move upward or downward. If you
press the middle of the switch once
more, source OSD will be displayed.
If you press the middle of the switch
and hold about a few seconds, the
TV will switch to standby mode. Main
menu OSD cannot be displayed via
control buttons.
Viewing the Back Connections
HDMI 1: HDMI Input1.
HDMI Inputs are for connecting a device that has a HDMI socket. Your TV is capable of displaying
devices must be connected via the HDMI sockets or Component Socket. These sockets can accept
either 720p or 1080i signals. No sound connection is needed for a HDMI to HDMI connection.
RF Input2. connects to an aerial antenna system.
Note: If you use a decoder or a media recorder, you should connect the aerial cable through the device
to the television with an appropriate antenna cable, as shown in the illustration in the following pages.
SCART 3. input or output for external devices. Connect the SCART cable between the SCART socket on the
TV and the SCART socket on your external device (such as a decoder, a VCR or a DVD player).
Note: If an external device is connected via the SCART socket, the TV will automatically switch to AV
mode.
VGA Input is for connecting a personal computer to the TV set.