Technical information

Practical A.E.G Upgrade 2006

Converting a springer to an AEG has been possible but impractical due to the

extensive efforts involved. However, with the introduction of the Cybergun M4

series springers, the story is destined to change. Look at the pictures below, we

have successfully fitted a Version 2 mechbox into a Cybergun Kitty Kat. The

whole process took less than an hour to complete (assuming you have the AEG

mechbox ready to go).

The Kitty Kat was designed from the ground up with AEG compatibility in mind.

Except for the pistol grip, the motor plate and the fire selector switch, almost all

parts can be used to support the conversion effort.

Note the following:

• The Cybergun springer receiver can take all V2 AEG mechboxes currently

available in the market.

• The Cybergun V2 mechbox does not fit with the TM pistol grip due to

difference in the layout of the wiring/screw holes.