Technical information

Practical A.E.G Upgrade 2006
Page 5 Copyright 2005,06 The AirsoftPRESS (Hong Kong). All rights reserved.
WHY (AND WHY NOT) IS IT NECESSARY TO REPLACE THE STOCK TAMIYA CONNECTOR?........................91
ARE NICD BATTERIES SUPERIOR TO NIMH BATTERIES FOR DRIVING UPGRADED AEG?........................92
HOW DO I OPTIMIZE THE OVERALL PERFORMANCE OF THE STOCK MOTOR? ..........................................93
IS IT POSSIBLE TO INCREASE THE TORQUE OF THE STOCK MOTOR? IF SO, HOW? ....................................94
WHAT ELSE SHOULD I BUY FOR A HIGH FPS CONFIGURATION?.................................................................95
WHAT IS WRONG WITH THE SODA CAN TEST?..............................................................................................96
WHAT IS RIGHT WITH THE SODA CAN TEST?................................................................................................96
WHAT IS THE MOST ACCURATE WAY TO MEASURE FPS? ............................................................................97
HIGH ROF UPGRADE ...............................................................................................................................98
WHAT ARE THE KEY ELEMENTS OF A HIGH ROF SETUP? ...........................................................................98
CAN I INCREASE THE ROF WHILE KEEPING THE FPS AT THE STOCK LEVEL BY USING 9.6V BATTERY?.99
VOLTAGE VS MAH – WHICH ONE MATTERS THE MOST? .............................................................................99
CAN I INCREASE THE ROF BY REPLACING THE MECHANICAL CONTACT SWITCH WITH A SOLID STATE
SWITCHING MECHANISM BASED ON
MOSFET?........................................................................................100
CAN I INCREASE THE ROF BY USING CAPACITORS AT THE POWER SOURCE? .........................................101
IS HIGH ROF A MAJOR CAUSE OF TAPPET PLATE BREAKAGE? .................................................................102
ROF-WISE, WHY (AND WHY NOT) SHOULD I REPLACE THE STOCK PLASTIC BUSHINGS WITH BALL
BEARINGS
?...................................................................................................................................................103
ROF-WISE, WHY (AND WHY NOT) SHOULD I REPLACE THE STOCK PLASTIC BUSHINGS WITH METAL
BUSHINGS
? ...................................................................................................................................................104
HOW ABOUT OIL CHANNEL BUSHINGS?......................................................................................................104
WHY (AND WHY NOT) SHOULD I BUY THE HIGH SPEED GEAR SET?..........................................................105
SHOULD I UPGRADE TO A TEFLON CYLINDER? .........................................................................................106
HOW ABOUT A HIGH SPEED CYLINDER SET?..............................................................................................106
WHAT MAKES A BALL BEARING SPRING GUIDE MEANINGLESS FOR A STOCK TM GUN? HOW TO WORK
AROUND
?......................................................................................................................................................107
IS THERE ANY CHEAPER ALTERNATIVE TO BALL BEARING SPRING GUIDE?.............................................108
WHY A BALL BEARING SPRING GUIDE ALONE MAY NOT INCREASE THE ROF?........................................108
CAN I USE A VERSION 2 SPRING GUIDE IN A VERSION 3 MECHBOX?.........................................................109
SHOULD I UPGRADE TO AN EG1000 FOR HIGHER ROF? ..........................................................................110
HOW DO I OPTIMIZE THE STOCK MOTOR’S RPM WITHOUT SPENDING MAJOR $? .................................110